HAWKER Linde L12 2PZB200 24V200Ah

HAWKER Linde L12 2PZB200 24V200Ah

HAWKER Linde L12 2PZB200 24V200Ah

The traction forklift battery produced by hawker | power supply Co., Ltd. is the most advanced technology and process at present, and also the most widely used product in the industry. For example, many famous brand manufacturers such as forklift trucks, locomotive tractors, electric cleaning vehicles and electric tour buses use hawkerpzs traction batteries. It conforms to DIN standards and mainly supports European standard forklifts such as Linde, Hangcha, JUNGHEINRICH, Hyster, BT and still. It conforms to JIS / BS standards and mainly supports JIS / BS standard forklifts such as nichiyu, Toyota, TCM, Komatsu, shinko and Nissan.

Monomer structure

Hawker traction battery uses mature tube positive plate technology. The positive plate adopts die-casting grid, and the active material is stored in a row of tubes made of polyester material; The negative electrode plate is a reinforced plate electrode plate. Between the positive and negative electrode plates, there are micropores and a raised diaphragm on one side. The battery cell shell is made of polypropylene material with high impact resistance and high temperature resistance, and the shell cover is heat sealed to prevent electrolyte leakage.

Pole terminal

Each positive and negative terminal is made of lead alloy and copper core terminal with internal thread. The cooperation between the pole and the compressed sealing rubber ring can effectively prevent the leakage of electrolyte.

Battery cell connecting strip

The battery cells are connected by fully insulated halogen-free flexible connecting strips. The method of fixing the connecting bar with bolts can make it easy and fast to take out the unit from the battery pack for maintenance or replacement.

Safety valve

Each battery cell is equipped with a safety valve to allow the gas generated during charging to escape. The operation of adding purified water and measuring the specific gravity of electrolyte can be carried out through the safety valve. The safety valve also has a baffle for the battery to prevent electrolyte surge.

Battery cover

The battery cover has a design that an electrolyte agitation system or a temperature sensor can be installed after punching.

Hawker aquamatic centralized automatic water adding system

Hawker aquamatic centralized automatic water adding system can add water to all battery cells in the battery pack from the central point of the battery system. As shown in the previous figure, the water filling safety valve of the system can automatically maintain the optimal liquid level of the battery cell, and also allow the gas generated during charging to escape and measure the specific gravity of electrolyte.

Electrolyte agitation system

Hawker electrolyte circulation agitation system works by using the air lifting principle and the pipeline system installed on the battery. The diaphragm pump blows the low-speed air flow into the battery, so that the air flow circulates in the battery case. This system can effectively prevent electrolyte stratification and ensure charging optimization.

advantage

● higher capacity under the same overall size

● higher discharge efficiency

● longer operation time and higher reliability

● in terms of capacity and size, it effectively integrates din and BS standards in European standards

Hawker traction battery for charged hydrolysate agitation system

● avoid electrolyte and temperature stratification during partial or full charging

● optimize the charging acceptance process of the positive and negative plates of the battery, so that the bearing capacity of the positive and negative plates is consistent

● compared with the traditional charging method, the charging time is reduced by 30% and the energy consumption is reduced by 20%

● avoid electrolyte and temperature stratification during partial or full charging

● optimize the charging acceptance process of the positive and negative plates of the battery, so that the bearing capacity of the positive and negative plates is consistent

● compared with the traditional charging method, the charging time is reduced by 30% and the energy consumption is reduced by 20%

Electrolyte layering and electrolyte circulation

Hawker ®  The dimensions of traction battery pzs (with bolt firm connection bar) comply with DIN / en 60254-2 and iec254-2 'l' series standards.

HAWKER Linde L12 2PZB200 24V200Ah