6ES7534-7QE00-0AB0Siemens PLC S7-1500 AI/AO

Overview

Application

Design

Function

Technical specifications

Overview

4 analog inputs/ 2 analog outputs

For flexible adaptation of the PLC to the corresponding task

For subsequent expansion of the system with additional inputs and outputs

For use in the tightest spaces

Application

Analog inputs record process signals such as pressure or temperature and forward them in digitalized format (16-bit format) to the control. They are suitable for the measurement of current (2-wire and 4-wire transmitters), voltage, and resistance, as well as for the connection of resistance thermometers and thermocouples (measurement types depend on the module).

Analog outputs convert a 16-bit digital value into a current or a voltage and output this to the process. They are suitable, for example, for controlling proportional valves or small servo drives.

The following analog input/output module is available:

AI/AQ 4xU/I/RTD/TC / 2xU/I ST

4 analog input channels;

16 bit resolution; accuracy +/-0.3%; one potential group; 10 V common mode voltage; parameterizable diagnostics; hardware interrupts (two upper and lower limit values); calibration during execution time.

2 output channels;

16 bit resolution; accuracy +/-0.3%; one potential group; parameterizable diagnostics; parameterizable substitute values for the outputs; calibration during execution time.

Module width 25 mm

Design

Mounting on the S7-1500 mounting rail using one single screw

25 mm modules: Standardized 40-pin front connector using push-in technology (cannot be used for 35 mm modules)

Connectable core cross-sections: 0.25 mm2 to 1.5 mm2 (AWG24 to 16), regardless of the front connector used

Prewiring position of the front connector

Front flap with expandable cable compartment, even if fully wired

Integrated shielding concept

Unambiguous labeling on front of module:

Module type

Article number

Hardware and firmware version

Channel numbers labeling

Cabling diagram

Included in the scope of delivery:

Infeed element, shield clamp, and shield terminal

One labeling strip for manual labeling

One U connector

Printed front door

Function

Uniform display and diagnostics concept:

Module status display for ERROR (red LED) and RUN (green LED)

Channel status display (channel activated or deactivated, green LED) or diagnostics display (red LED)

Display for monitoring the 24 V DC supply voltage (green LED)

Supported functions:

Consistently high resolution of 16 bits

Identification and maintenance data IM0 to IM3

Firmware update

Channel-specific parameter assignment

Hardware interrupts; two upper and two lower limits can be parameterized

Channel-granular diagnostics (depends on measurement type/measuring range)

Calibration during runtime