Msp430f5437aipn 16 bit ultra low power microcontroller 32-bit HW multiplier

explain

Ti MSP series ultra-low power microcontrollers have a wide variety, and each member device is equipped with different peripheral sets to meet the needs of various applications. This architecture works with a variety of low-power modes and is optimized to extend battery life in portable measurement applications. The device has a powerful 16 bit RISC CPU

16 bit register and constant generator help to achieve higher coding efficiency. This digital controlled oscillator (DCO) enables the device to wake up from low-power mode to active mode within 3.5 µ s (typical).

Msp430f543xa and msp430f541xa series microcontroller configurations include three 16 bit timers, a high-performance 12 bit ADC, up to four USCIS, a hardware multiplier, DMA, RTC module with alarm function and up to 87 I / O pins.

characteristic

• low supply voltage range:

3.6V to 1.8V

• ultra low power consumption

– active mode (AM):

All system clocks are active

At 8MHz, 3.0V and when the flash program is executed

230 µ A / MHz (typ.)

At 8MHz, 3.0V and when the ram program is executed

110 µ A / MHz (typ.)

– standby mode (lpm3):

Real time clock (RTC) with crystal, watchdog, power monitor

Available, full ram hold, fast wake-up:

1.7 µ a at 2.2V and 2.1 µ a at 3.0V (typ.)

Low power oscillator (VLO), universal counter, watchdog and power

Source monitor available, full ram hold, fast wake-up:

1.2 µ a at 3.0V (typ.)

– off mode (lpm4):

Full ram hold, power monitor available, fast wake up:

1.2 µ a at 3.0V (typ.)

– off mode (lpm4.5):

0.1 µ a at 3.0V (typ.)

• at 3.5 μ Wake up from standby mode within s (typical)

• 16 bit RISC architecture

– extended memory

– system clock up to 25MHz

• flexible power management system

– fully integrated LDO with programmable regulated core supply voltage

– power supply voltage monitoring, monitoring and undervoltage protection

• unified clock system

– phase locked loop (FLL) control loop for frequency stability

– low power low frequency internal clock source (VLO)

– low frequency trim internal reference source (Ref)

– 32kHz crystal oscillator

– high frequency crystal oscillator up to 32mhz

• 16 bit timer TA0 with five capture / compare registers,

Timer_ A

• 16 bit timer TA1 with three capture / compare registers,

Timer_ A

• 16 bit timer with seven capture / compare shadow registers

TB0，Timer_ B

• up to 4 universal serial communication interfaces (usci)

– USCI_ A0、USCI_ A1、USCI_ A2 and usci_ A3

All support:

• enhanced universal asynchronous transceiver (UART) supports automatic wave

Specific rate detection

• infrared data communication (IrDA) encoder and decoder

• synchronous SPI

– USCI_ B0、USCI_ B1、USCI_ B2 and usci_ B3

All support:

• I

2C

• synchronous SPI

• 12 bit analog-to-digital converter (ADC)

– internal datum

– sample and hold

– auto scan feature

– 14 external channels, 2 internal channels

• hardware multiplier supports 32-bit operation

• serial on-board programming without external programming voltage

• 3-channel internal DMA

• basic timer with RTC features

• the device comparison summarizes the available product family members

Scope of application

• analog and digital sensor systems

• digital motor control

• remote control

• thermostat

• digital timer

• handheld instruments