Ethernet over Coax converter Slave Unit with Wifi

BD-EOC-S4-W is the EOC slave based on HomePlug AV solution for Ethernet access over coax. It works together with EOC master which is based on HomePlug AV solution as well to construct a two-layer Ethernet data transmission channel on CATV coax cable, provide the Ethernet access service based on the existing coax cable networking.

The built-in wifi module based on the single chip AR9331 which integrates an 802.11n 1×1 MAC/BB/ radio with internal PA and LNA. It supports 802.11n operations up to 72 Mbps for 20 MHz and 150 Mbps for 40 MHz channel respectively, and IEEE 802.11b/g data rates.

BD-EOC-S4-W is slave with 4 Ethernet ports with built-in Wifi.

• Low-frequency modulated EOC slave is adopted INT7400 chipset, HomePlug AV solution

• Work at low frequency between 7.5MHz and 65MHz, without affecting the existing CATV

• Physical layer speed: 500Mbps; Max MAC layer throughout is 300Mbps

• Support 4 Ethernet ports with 10/100Mbps auto-negotiation function

• Support VLAN configuration based on slave unit or slave’s Ethernet ports

• Support broadcast storm control

• Support WEB, CLI and SNMP management

•  MIPS 24K processor operating at up to 400 Mhz.

•  DD2 memory up to 512 Mb.

•  SPI NOR Flash memory up to 64Mb.

•  4LAN ports and 1 WAN port

•  SPI support.

Network access

VOD(video on demand service)

IPTV

Video Surveillance