Brass terminal, brass heat sink, brass connecting spring

Metal stamping is a process that uses punch and die to deform or fracture iron, aluminum, copper and other plates and heterosexual materials to achieve a certain shape and size.

Metal stamping is sometimes called sheet metal forming, but it is slightly different. The so-called plate forming refers to the use of plates, thin-walled tubes and thin profiles as raw materials. The forming method of plastic processing is collectively referred to as plate forming. At this time, the deformation in the direction of thick plate is generally not considered.

Stamping process can be roughly divided into two categories: separation process and forming process (also divided into bending, deep drawing and forming). The separation process is to separate the stamping part from the blank along a certain contour line in the stamping process, and the quality of the separation section of the stamping part should also meet certain requirements; The forming process is to make the stamping blank plastic deformation without damage and transform it into the required finished shape.

Dongguan Licheng hardware electronics co., LTD., founded in 2010, our factory is located on approximately the dongjiang river, with Chinese electronic town --  shijie town, dongguan.

Our factory is specialized in production of metal stamping parts, high and low frequency transformer steel CLIP, spring CLIP (such as RM, ETD, EFD, EF, ER, EP, PQ, etc) and all kinds of electrical and electronic hardware parts, copper needle, KAPTON film, etc. Its products are widely used in modern communication equipments, digital technology and household electrical appliances, etc.

To cater to today's era of science and technology, our factory has introduced advanced production equipment, testing equipment, has experienced r &d and technical personnel, and constantly improve the internal management level, scale, standardization, efficiency, innovation of management mode, to ensure efficient production, quality。