thermoplastic road high reflective marking paint

Hot melt Pavement Marking Coating

I. Product introduction Hot melt road marking coating is composed of petroleum resin, EVA, PE wax, fillers and other materials. It is a powder at room temperature. It is heated to 180-200°C with hot melt kettle, and it is flowing after stirring and keeping heat for 3-5 minutes. It has the characteristics of linear fullness and strong wear resistance, and reflective microbeads are scattered on the surface during construction. It has good reflective effect at night, and is widely used in expressways and urban roads. According to the use environment, customer requirements, we will provide different types of specifications for you to choose. 

II. Product Characteristics 1. Strong adhesion: reasonable resin content, special rubber elastomer added in the bottom oil, super adhesion. Ensure that the construction process is reasonable and there will be no shedding phenomenon. 2, good anti-cracking: hot melt mark line due to temperature difference, easy to produce cracking phenomenon, add sufficient amount of EVA resin in the paint, prevent cracking. 3, bright color: the use of top coating pigment, reasonable ratio, good weather resistance. Long-term exposure does not discolor. 4, good fouling resistance: the quality and amount of PE wax is the key to affect the fouling resistance, we use PE wax is the best PE wax in the world. 

III. matters needing attention 1, to ensure that the working face is clean and dry, it is recommended that the 4647 temperature of the construction is above 0 degrees, (low temperature construction, please properly raise the material temperature) 2. When the coating is melted, the temperature should be controlled between 180 and 220 degrees. After melting, it is fully stirred and kept warm for 3-5 minutes before discharging, so as to fully reflect the performance of the hot melt coating. 3, the bottom oil treatment should be sufficient, until the bottom oil is completely dry before coating marking, the newly completed cement road surface, as far as possible to delay the construction after three months or two times the bottom oil treatment, otherwise easy to appear the phenomenon of marking off. 4. In the construction of the road section with large traffic flow, after coating the bottom oil, please place the warning sign to prevent the wheel rolling, taking away the bottom oil and leaving dust, otherwise it is easy to fall off part of the marking. 

IV. The using qty:1 ton

Film Thicknes: 1.8MM

Coating Area: 225 square meter

Base coat qty: 32kgs

Glass beads: 100kgs.