Desoldering Pump With Aluminum Body

Top-notch Quality. The solder sucker has an aluminum bronze frame and a high pressure vacuum which can remove solder from a printed circuit board effectively.

Solder Wick Braid. The desoldering wick is 2.5mm wide and 1.5m in length. Weight: 0.4oz. With low residue design, this solder braid will help clean spare solder on the pin away to avoid short circuit, especially in small, hard to reach areas.

The desoldering pump can be used with only one hand, either your right or left hand.

Solid Construction. The solder sucker has plastic backing to ensure stability.

The solder sucker measures 7.48"X0.79", which will fit your hands perfectly no matter if you are left-handed or right-handed. With metal body and high pressure vacuum, this desoldering pump can help you suck the solder away effectively.

Step 1: Press the plunger down until it is been locked and you will hear a click;

Step 2: Make the tip of the soldering iron to the solder joint and allow the solder to become fully liquid;

Step 3: Move the tip of the pump next to the molten solder. Move the iron out of the way and immediately cover the liquid solder puddle with the pump's tip. Pull the trigger;

Step 4: Repeat this process if necessary.

Product size: 19.5*2cm

Packing: blister pack

Carton: 52x33.5x49cm

QTY: 400pcs/ctn

Weight: 16kgs