Hands Free Soap Dispenser Behind The Mirror Electric Dish Soap Dispenser Automatic Hand Soap Dispenser

How to clean automatic soap dispenser

To clean the pump, simply flush your pump with warm water and a bit of vinegar. For stubborn clogs, use a bit more vinegar ; a toothpick may come in handy. Allow it to dry thoroughly before adding soap to the dispenser. It is recommended to flush your pump with warm water once a month ; or each fill up.

Description:

1 it can match and use together with all kinds of faucets perfectly.

2.It adopts the infrared ray emission and reception technology, which is completely touch-free so that it is convenient and safety.

3.The spout is made of brass plated with chrome and its plating is enhanced, so that the product can maintain a long term fresh color and become more durable.

4.Time-adjustable and amount-adjustable, the users can adjust the dispensing time and foam amount, and it can be used in various

How does automatic soap dispenser work in dish dishwasher

The thing that makes the detergent door pop open instead of falling open in the dishwasher is a tiny spring that powers the soap dispenser. When the right time comes in the cycle, the spring triggers and pops the soap dispenser open so that hot water jets can instantly cause suds and blast the soap around the dishes.

Products Features:

●Humanized appearance design, convenient installation design and simple liquid adding design.
●Adaptive or adjustable sensing technology.
●Exclusive development of soap pump technology, can automatically stop reflux.
●Optional AC/DC power supply.
●1000 ml liquid storage bottle.
●Suitable for soap solution viscosity: 100-3800cPs.
●Including necessary installation hardware.
●Meets ASME A112.18.1/CSA B125.1 standard.

●Meets US ADA regulations and CJ/T 194-2004 standards.

Specification:

1) Automatic on/off: Soap dispenser automatically supplies foam soap as the dispense-time set as soon as hands in sensor range. Soap dispenser automatically stops working if hands out of sensor range..

2) Adjustable sensor range and soap volume by a remote controller (optional).

3) Low power indication: Soap dispenser sensor flash to indicate that it is time to replace existing batteries with new ones if there is not enough power going to the unit. No soap dispensed at this time if hands in the sensor range.

4) Four D-type alkaline batteries shall last approximately 3000 times/month for 6 months.

5) It is suggested cleaning the soap hoses with clean tap water if you will not use the soap dispenser for more than 1 week. How to clean: please pour clean tap water into the soap bottle and sense the soap dispenser until the tap water dispensed.

How to reset a automatic soap dispenser

If the soap dispenser is idle for a period of time, it is possible to condense some soap solution in the soap dispenser. At this time, the following methods can be used: (1) if the amount of soap is small, stir it with warm water, so that the soap can be reduced to liquid; (2) if the above method is not feasible, remove the condensed soap, add warm water, and use the soap dispenser many times Until the warm water runs dry from the soap dispenser, that is to say, clean the whole soap dispenser, and then add the soap solution again to use.