Pultrusion machine for FRP profiles

FRP Pultrusion Equipment

Scope of application of equipment

Suitable for solid products with large cross-section, such as cable bridge, guardrail, square bar, round bar, etc.

Equipment characteristics

The whole machine is controlled by PLC, and the traction control system is controlled by automatic and manual control system.

Detailed introduction of equipment

1. The whole machine adopts PCL control, and the traction control adopts automatic and manual control system.

2. The products are pressed up.

3. Cutting saw adopts variable frequency speed regulation and fixed length cutting.

4. Equipped with hydraulic oil cooling system and fault alarm system;

5. Conventional shape size: 9000 mm long * 1200 mm wide * 1500 mm high;

6. Traction force (t): 10-30 adjustable;

7. Clamping force (t): <5-30 adjustable;

8. Traction speed mm/min: 50-1500;

9. Traction reciprocating stroke mm: > 600;

10. Holding stroke mm: > 100;

11. The length of die stand is mm:900.

12. Mould clamping mechanism: screw clamping;

13. Cooling water requirement of oil tank: temperature 0-15 C & flow rate not less than 100 liters/hour;

14. Demand of automatic cutting gas source: applicable pressure 0.4-0.8 MPa;

15. Heating zone: Contactor heating is used in heating zone, which can ensure that the fluctuation range of temperature control is within the range of (+) 5 (+) 5 (+) 5 (+) 5 (+) 0-300 (+) C) and that the heating power can be controlled at 6 KW per zone in 3-6 zone.

16. The cooling system of the equipment adopts cooler to cool the hydraulic oil. Its advantages are fast cooling, maintenance-free and water-cooling.

17. The electrical control system of this equipment adopts logic control, which is mature and easy to operate.

18. Total power demand for plant services: 10-12KVA, 380V voltage;

19. Installation length of production line is nearly 30000 mm.