Dynamic Mechanic Loading Tester/Solar panel testing equipment / PV Module testing machine with IEC61215 & IEC61730 testing

Dynamic Mechanic Loading Tester/Solar panel testing equipment / PV Module testing machine with IEC61215 & IEC61730 testing 

Testing standard

It's conform IEC61215-22:2016 & IEC61730-2:2016 testing standard 

Purpose

This test is to determine the ability of the module to withstand wind , snow , static or ice loads

The Main Technical Specifications

Testing Procedure

1.Equip the module so that the electrical continuity of the internal circuit can be monitored continuously during the test

2.Mount the module on a rigid structure using the method prescribed by the manufacturer including the mounting means (clips/clamps and any kind of fastener) and underlying support rails, if t here are different possibilities each mounting method needs to be evaluated separately , for all mounting methods , mount the module in a manner where the distance between fixing points is worst case, which is typically at the maximum distance. 3.On the front surface , gradually and uniformly apply the test load, load uniformity needs to be better than ±5% across the module with respect to the test load, maintain his load for 1h

4.Apply the same procedure as in step c to check back surface of the module or as uplift load to the front surface

5.Repeat step c and d for a total of three cycles