Professional Carbon Dioxide Incubators for School Laboratories and Industrial Laboratories, Global Supply

HCP series CO2 incubator：

Forced convection / Liquid crystal display / UV sterilization / Voice prompt

Use for cells, tissues, and bacterial culture; is the key equipment to carry out essential immunology, oncology, genetics, and bio-engineering. Widely used in microorganisms, agricultural science, drug research, and production.
Microcomputer intelligence control, constant temperature with timing, over-temperature function; gas distribution type, CO2 recovery time ≤concentration×1.2Min. built-in UV sterilization lamp, tempered glass door, adopt door heating control system which can effectively avoid frost in a glass door.

Method of use

1. Carbon dioxide special pressure reducing valve installed in the carbon dioxide cylinder, the joint must not have leakage phenomenon. The pressure relief valve output joint is fitted with a pressure rubber hose, and connected to the carbon dioxide intake joint behind the incubator, and then fixed with a compression ring, there is a leakage at the compression joint. Carbon dioxide cylinder gas main valve is temporarily closed.

2. Before switching on the power, wipe the chamber with alcohol, and then use ozone disinfector to sterilize it for one hour.

3. Connect the water pipe to the lower left side of the tank and add and drain port (provided by the user of the tank), open the outer door of the tank, and visually observe the water level at the bottom of the workshop to about 10 ~ 15mm.

4. boot

Power on, main power switch set "1", power indicator light.

1) box temperature and parameter setting

Power on display "888..." After 3 seconds, enter a state of normal operation, press the main heating temperature setting button "Test" box set temperature controller into the state, the controller temperature window bottom set prompt "SP" display box, display boxes on the temperature setpoint, the user can according to need to modify the parameters, click the button again, exit temperature box set status, the value is automatically saved. Long press the box temperature setting key "Test" for 3 seconds to enter the box temperature internal parameter setting state, and then long-press the key for 3 seconds to exit the state.

E-mail: kenton@kentonchina.com

After-sales: service@kentonchina.com

CO2 bacterial incubator:

/co2-incubator/20170602/30.html