cnc stone water cutter from China/3000mmx2000mmx150mm waterjet

There are four parts in our stone water  cutter . They are intensifier pump; cutting table; CNC controller and Auto abrasive feeder.  

The technical parameters for stone water  cutter  showing in the following chart:

Dual-Core Waterjet Debut

APW pioneered “Dual-Core” waterjet, which integrated SIEMENS motor, imported REXROTH hydraulic pump and hydraulic valves assembly, American A&V intensifier, American high pressure tube and stainless steel water tank. This dual intensifiers design represents another landmark in APW history.

They has been widely used in all APW waterjet series. UP to now, APW is still the only waterjet manufacturer holding this advanced technology in China.

Imported components

We adopt the imported components like Rexroth hydraulic pump; USA intensifier; Siemens motor; Omron PLC; Yaskawa servo driver, Yuken direction control valves etc. The whole parts of intensifier is assembled in USA (not just some parts), most of the smaller parts are also imported from USA to ensure its good stability during cutting, durability and long working service life.

1. What are the benefits of purchasing a waterjet comparing CNC plasma or a laser ?

Versatility
Abrasive waterjet can cut almost anything – from metal to stone to glass to composites to ceramic.
Laser and plasma cut with heat, and so can only cut materials that have the right thermal properties. Metal is almost always the target material in industry for these heat-based processes. And mild steel is almost always the metal that is cut by them. In addition, plasma can only cut things that are electrically conductive. To optimize laser and plasma cutting, change to gasses is required. No change to waterjet parameters, except speed, is usually required for any material. 
Thickness
Waterjet can cut very thin and up to 150mm (sometimes more) of any metal, glass, stone, composite, etc.
Laser cuts very thin and up to 20mm.
Plasma cuts from about 25mm up to 30mm.
Edge finish
Nothing cut by a plasma or laser will be as high of quality of an edge as a waterjet. We leave behind a smooth edge. No heat affected zones or mechanical stresses are introduced. The plasma and laser cut with heat (we cut with supersonic erosion). Plasma and laser therefore will leave behind a heat affected zones, mechanical stresses, and especially with plasma, dross 'drips' on the edge.

Please contact us for more information of our water jet cutting machine.

2. What kind of material does your machine can cut?

There are plenty materials our water jet machine can cut , such as metal stone glass foam plastic rubber, ect.
4-axis was professionally designed for mable pattern and medallion.
5-axis was professionally designed for 3D materials.

3. What's your machine's max.cutting thickness?

The max.cutting thickness of our waterjet depends on the materials you cut .
Generally speaking, the thickness of our water jet cutting machine can be up to 150mm, virtually Z constraint is the only limit to thickness.

4. How much training is required to learn how to run a waterjet system?
An operator with no experience should be able to learn how to operate and maintain a waterjet cutting machine with as little as one weel of training. New CAD/CAM nesting software offered by APW make it possible for an operator with no programming experience to program the machine with only a few hours of training.

More information about APW waterjet cutting machine price pls contact us at hotline: +86-024-24699053