Water Spray Test Equipment for Metal Surface Treatment

Water Spray Test Equipment for metal surface treatment

Corrosion Test Meter/Uses:

The company specializes in the production of neutral salt spray test into the test chamber , low temperature test chamber, high and low temperature ( alternating ) test chamber , high and low temperature ( alternating ) heat test chamber and so on. According to user requirements , custom specifications for various models of various types and sizes of walk-in test chamber .

Technical Requirements

1.imported from Germany, high temperature and high humidity corrosive Class A gray PVC sheet .

2.tank heating tank for the interior heating .

3.saltwater tank set up in the housing bottom .

4.temperature control accuracy : about 0.1 celsius degree; over-temperature protection device.

5.External dimensions 1000 * 750 * 800.6

Water Spray Test Equipment/Hole incubator.

1.temperature range 0-100 celsius degree.

2.temperature control accuracy 0.1 celsius degree.

3.effective volume greater than 15L.

Technical indicators:

1.temperature range : -40 celsius degree, -20 celsius degree ~ +100 celsius degree

2.humidity range : 30 percent ~ 98 percent RH

3.the temperature fluctuation : about 0.5 celsius degree

4.the temperature deviation : less than 2 celsius degree

5.humidity bias : 3 percent RH

Safety devices :

1.power overload, passing control back to the overload, short circuit protection

2.ground fault protection, motor overload protection

3.over-temperature protection

pression overvoltage, overload

5.for the protection of equipment,all alarms are automatically cut off the power , and send voice prompts.

Salt Test Chamber/Use site conditions :

1.Temperature:15 celsius degree ~ 35 celsius degree

2.Relative humidity : not more than 85 percent RH

3.Around without strong vibration,no strong electromagnetic fields

4.No high concentrations of dust around and corrosive substances

5.No direct sunlight or other sources of heat radiation

6.No strong airflow around when you need to force the ambient air flow,air flow should not be blowing directly on the box .