High luminous flux plastic T8 led tube

Hot selling products!!!

Features:

1, Energy-saving: It can save 70% energy comparing traditional lamps.

2, Environmental: No Hg, all are recyclable. In accord with ROHS.

3, Power factor can be more than ≥0.9, It can save a lot of power.

4, Life Span: LED tubes` Warranty=50 000H, Fluorescent tubes=5 000H.

5, Constant Current, no flicker, no buzz, which can eliminate eyes` fatigue.

6, Can reach the max light within 0.5m, but fluorescent tubes need 5 minutes.

7, Input Volt can stand a large range of AC85-265V, it is especially good for using in the places where the volt is not steady.

8, It puts less heat out than traditional lamps, so the efficiency is very high.

9, 3 proprietary technologies:

a) Using the G13 base, which can used in T8, T9.

b) 3 leds are connected in serial connection; but other companies use much more than 10pcs in serial connection.

That means, if 1 led goes off, all the 10leds will go off.

c) Our tubes can be connected on any two pins of both ends.

So, if there is the ballast there, it doesn`t matter. Just have to connect correctly.

10, Materials: Plastic body. quite light in weight.

11, High in luminous flux, small light decay, high color index.

12, Heat output system: The system is very important in led lamps. Poor system will lead short life span, big light decay.

ANPU T8 LED Tube is perfect in heat output.

a) PCB & The heat-conducting glue:

PCB-We are using dual PCB, currently, most companies are using the single PCB.

Top Heat-conducting glue inside: In the markets, most led tubes are without the heat-conducting glue.

b) The body: Stereoscopic design. It can stand as what it is under huge forces. Even after twisting, it can stay back as it is.

c) Heat inductive plastic body.