Durable Aluminum LED D6A Underwater Dive Lights / Flashlight with AA Batteries

Delivery Time:3-5 days
Certification:CE,FCC,MSDS

Durable Aircraft Grade Aluminum LED W12A Underwater Dive Lights / Flashlight with AA Batteries

REPLACEMENT PARTS

CAT#                  DESCRIPTION

D6A8                  O-ring

D6A9                  Lens

PRODUCT SPECIFICATIONS

Model	W12A Diving Light
Bulb	Cree XM-L U2 (Max 650 lumens)
Color temperature	6500K
Three output levels	High> Low>Strobe
Runtime	High: 120 min, Low: 240 min, Strobe: 150 min
Reflector	Glossy Aluminum reflector
Lens	8mm Polycarbonate Board
Body material	Durable aircraft-grade aluminum
Angle of light beam	5° hot spot, 110° periphery
Surface treatment	Premium Type III hard-anodizing
Color	Black
Battery	18650 Li- ion battery *1
Circuit Protection	With battery polarity reversing protection
Operation voltage	2.8V to 4.5V
Waterproof	100 meters underwater
Dimensions	208(length)*36(dia. of body)*65mm (dia. of head)
Weight	550 grams (without batteries); 690 grams (with batteries)
Underwater Weight	560 grams (with batteries)
Impact resistance	1.5M

BATTERY INSTALLATION

Remove the tail by turning counter-clockwise. Remove used batteries and replace with fresh batteries as shown by the polarity stickers. Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.

ON/OFF

Turn the tail clockwise until the light activates. DO NOT OVERTIGHTEN.

To turn the light off, back off the tail counter-clockwise until the light goes off.

Continue to back off for approximately one full turn to eliminate the possibility of the light activating accidentally in storage. For underwater use, backing off too much will allow water to enter past the o-ring.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please remove the batteries during transportation to prevent it from misoperation.