2200 Lumens 30 Watt COB LED Scuba Diving Lights / Torch With Type III Hard-Anodizing

Certification:CE, RoHS

Aluminum Goodman Handle DG90 Scuba Diving Lights SST-90 2200 Lumens 30 Watt COB LED

PRODUCT SPECIFICATIONS:

Model	DG90 Goodman Handle Diving Light
Bulb	SST-90 LED *1 (max 2200 Lumens)
Modes	High> Low>Strobe> off
Runtime	High (3.0h); Low (8.0h); Strobe (4.0h)
Color temperature	6000K
Reflector	Glossy Aluminum reflector
Lens	8mm Polycarbonate Board
Body material	Durable aircraft-grade aluminum
Angle of light beam	8° hot spot, 110° periphery
Surface treatment	Premium Type III hard-anodizing
Color	Black
Battery	Rechargeable Li- ion battery pack (18650 battery*6)
Battery Indicator	100%-50%: Green; 50%-30%: Yellow; 30%-10%: Red; Below 10%: Red Flashing; Below 5%: switch off
Charging	Can be charged directly on the light, with battery over-discharging protection, polarity reversing protection
Fully charging time	8-10h
	With gas release valves
Operation voltage	9V to 13V
Waterproof	200 meters underwater
Dimensions	213.5mm (length)* 78.0mm (dia. of head)
Weight	1300 grams (with battery pack)
Underwater Weight	640 grams (with battery pack)
Impact resistance	1.5M

BATTERY CHARGING

Plug the charger in the wall power socket, the indicator light is green in the free-load status. Plug the port of the charger in the ports on the light. (the positive and negative polar doesn’t matter, both ways work.) The indicator light is red if the battery is not fully charged; it will turn green after fully charged. Take out the charger and use the light.

ON/OFF

Push the switch to turn it ON.

MODES CHANGING

Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please put the switch sleeve on light head during transportation to prevent it from misoperation.

If the switch gets stuck, please put some washing-up liquid in the slot of the switch and push the switch back and forward several times till it move smoothly again, then clean the light in the fresh water.

WARRANTY RETURN POLICY

Please contact your local distributor or retailer for information on how to handle your warranty items.

REPLACEMENT PARTS

CAT#             DESCRIPTION

DG908           O-ring

DG909           Lens