Aircraft Grade Aluminum Zoomable D10U Underwater Video Lights 680 Lumens

Certification:CE, RoHS

Aircraft Grade Aluminum Zoomable D10U Underwater Video Lights Max 680 Lumens

PRODUCT SPECIFICATIONS

Model	D10U zoomable Diving Light/underwater photographing light
Bulb	CREE XM-L U2 LED (Max 680 Lumens)
Color temperature	6500k
Three output levels	High> Low>Strobe
Runtime	High: 70 min, Low: 320 min, Strobe: 150 min
Reflector	No Reflector
Lens	Aspheric lens
Body material	Durable aircraft-grade aluminum
Angle of light beam	6°- 68° zoomable
Surface treatment	Premium Type III hard-anodizing
Color	Black
Battery	18650 Li- ion battery *1
Circuit Protection	With battery over-discharging protection, polarity reversing protection
Operation voltage	2.8V to 4.5V
Waterproof	60 meters underwater
Dimensions	129-144mm (length)*23(dia. of body)*45mm (dia. of head)
Impact resistance	1.5M
Weight	190 grams (without battery); 240 grams (with battery)
Underwater Weight	200 grams (with battery)

BATTERY INSTALLATION

Remove the tail by turning counter-clockwise. Remove used batteries and replace with fresh batteries as shown by the polarity stickers. Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.

BATTERY CHARGING

Plug the charger in the wall power socket, the indicator light is green in the free-load status. Put the battery in the slot of the charger. The indicator light is red if the battery is not fully charged; it will turn green after fully charged. Take out the fully charged battery and use them in the diving light.

ON/OFF

Turn the tail clockwise until the light activates. DO NOT OVERTIGHTEN.

To turn the light off, back off the tail counter-clockwise until the light goes off.

Continue to back off for approximately one full turn to eliminate the possibility of the light activating accidentally in storage. For underwater use, backing off too much will allow water to enter past the o-ring.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

Zoom

Twist the head of the light to zoom the beam.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please remove the batteries during transportation to prevent it from misoperation.

WARRANTY RETURN POLICY

Please contact your local distributor or retailer for information on how to handle your warranty items.

REPLACEMENT PARTS

CAT#                  DESCRIPTION

D10U8               O-ring

D10U9               Lens