Digital crimp height micrometer

Digital crimp height micrometer

ith Ratchet Stop for constant force

With SPC output; With digit counter

Supplied in fitted plastic case

Display Type Digital LCD/Vernier

Thimble Mechanism Ratchet Stop

Measuring System Inch/Metric

Type External Micrometer 

This is a micrometer specifically designed to measure crimp height. It has an anvil (thin blade) that supports the 

top of the crimp while a spindle (pointed section) contacts the bottom radial surface.

Power 

1. The battery is a SR44, 1.5V. Replace the battery when the display is blurring or the “ “ appears. 

2. If the micrometer is not in use, the power will shut off in 5 minutes. The micrometer will turn on when pressing 

the ON/OFF key or turning the spindle. 

3. Power off the micrometer when not in use, by pressing the ON/OFF key. 

4. Remove the battery if the micrometer is not being used for a long period of time

How to measure the crimp height

1. Complete the crimping tool set-up procedure. 

2. Crimp a minimum of five samples. 

3. Place the Anvil (flat blade) of the crimp micrometer across the top of the dual radii of the conductor crimp. Do 

not take the measurement near the conductor bell mouth. 

4. Rotate the micrometer spindle until the point contacts the bottom radial (curved) surface. Do not excessively 

tighten the point against the terminal. 

5. Record crimp height readings. A minimum of five crimp height readings is necessary to confirm the crimping 

tool set-up. A minimum of 25 readings should be taken for determining process capability

ROk International Industry Co.,limited supply all kinds of special micrometer, OEM. 

like tube micrometer, Blade micrometer, disk micrometer, tip micrometer, spline micrometer.