TY24C Pneumatic Rock Drill

TY24C PNEUMATIC ROCK DRILL

TY24C pneumatic rock drill are light and small types designed on the basis of less recoil and of safty.They are suitable to the secondary breaking work,the work of drilling down bedrock,etc.

Overall weight                                          27kg

Over length                                           610mm

Cylinder Bore                                         66.7mm

Piston stroke                                           68mm

Air consumption                                  2.7 M3/min

Shank size                                         22*108mm

Operation Health and Safety:

Make sure that users will empoly safe working pratics and will observe any related legal requirements when using and overhauling compressed air operated machine.

The following notes augment instructions given elsewhere in this publication and they are intended as a guide to the safe use of this machine and its associated compressed air supply under working conditions.

General:

   Operate at the recommended air pressure for the machine,usually this is 6 bar for hand held machines.

   Ensure that the air supply hose is suitable for the working pressure and that hose end fitting and connections are correct type and size.

   Do not use damaged,frayed or deteriorated hoses.Always store them properly after use away from heat sources or sunlight.A hose failure can cause injury.

   If using compressed are for cleaning down equipment do so with extreme caution.Take care not to blow dirt at yourself or other persons or into machinery.Use eye protection.

   Never apply compressed air to your skin or to clean dirt from your clothing and never direct it at another person.

   When blowing through a hose or air line,ensure that the open end is held securely.A free end will whip and can cause injury.Open the supply air cock carefully and ensure that any particles are ejected safely.A blocked air hose can become a compressed air gun.

Close the air cock at the compressor or the supply line and release the line air pressure before disconnecting the hose.The air cock should be located within easy reach of the work area.

Exposure to excessive noise can damage your hearing.Wear ear muffs or other protection.

Noise-reducing mufflers fitted to machine lessen the noice health hazard and reduce environment noise.Detachable mufflers must be fitted correctly and replaced if damages.

Maintenance and Repair:

  Disconnect the machine from the air supply before doing any work on it.For dismanlting,hold the machine firmly in vice or fixture.Use the correct tools for dismantling and assembling.When using a solvent or chemical cleaner,Follow the manufacturers instructions.Before clearing the machine for use,Make sure that it has been assembled correctly with fasteners correctly tightened.

Use of Machine and Tools:

   Use only approved tools,Make sure that the tools shank size is correct for the machine.

   Don't use blunt tools or those which are either worm excessively or damamges in any way on the shank or stem.A steel which breaks in use can cause injury.

   Don’t frozen tools.In freezing condisions store tools undercover,Perferably in a warm building.Freezing temperatures can make hardened steels brittle and cause breakage.

Connect the hose to the machine before turning on the compressed air supply.Ensure that the machine controls are in the “off” position.

   Position the machine correctly and hold in firmly before operating the controls.Don’t operate the machine in such a manner that would cause personal injury.

   Persons operating,assisting in operating or working near the machine should position themselves in such manner that they will not be struck or lose their balance if the machine slips or if the drill steel either breaks or stick,and cause personal injury.

   Where using vibrating tools continuously and particularly in cold weather,wear suitable protective gloves and keep the hands warm to avoid”white flinger”

   When handling lubricants regularly,wear suitable gloves of impervious material.Clothing contaminated by lubricants should be changed.