high quality wood pellet mill lucerne pellet making machine

Our company is professional in making pellet machine, we hold that quality first management idea. We have different pellet mill models, and can also customize according to the request of different clients. It is our new design to aim at biomass materials, can attach many kinds of materials, such as sawdust, wood branch, rice husk, cornstalk, cotton shell, palm fiber and peanut shell ect. We adopt advanced technology, stationary wheel adopt good alloy steel. This alloy steel can decrease the temperture of the gear, increase capacity, improve load-bearing capacity, and make it durable, can be used for a long time.

You can chang the length of final product by choosing different mold with different hole diameter.

Pictures:

Specification:

Parameter:

Spare parts:

Service life of roller and die is 300-500 hours under normal running condition. Most of dies can 

be used on both sides, it is recommended to replace roller and die at the same time. Make sure 

there are no hard materials mixed with raw materials. Because it is easy to destory the die and 

roller. 

Advantages:  approved by CE, ISO9001

                                  high capacity with good quality and low investment

                                  steaty transimission, low noise   

                                  good alloy steel and reasonable design feeder

Materials: Your raw materials must be powdery, if not, you need a crusher to crush them. And the moisture should be about 12%-18%, if not, you should dry them or add more water. You should debug the pellet machine before using it, when everything is  prepared, you can start it.

Available materials:

Final products:

 Packing:  The whole machine is not easy to pack, so first packed in plastic film by seperated parts, the plastic film can make the machine avoid rusting, then packed in fumigation-free wooden case.

Shipping: We will choose the most convenient one to you.

Question: Why did motor halt suddenly?

Answers: 1. Voltage is low.

                     2. Pressure between roller and die is too high.

Solutions: 1. Start the mill again when voltage is stable.

                          2. Adjust the clearance between die and rollers.

Gongyi Dongxing Company

Add: Xinhua Road, Gongyi City, Henan Province, China

Tel: 86-371-85617836

Fax: 86-371-85617836

Website:  

Welcome to visit our company website at any time!