OSG Taiwan Nut Tap.Nib tap

(1)The thread length and shank length are designed to be longer,          considering the continuous processing till the shank is full of nuts.

(2)Chamfer length is 75% of thread length.

(3)Use threaded engagement to lower the cost.

(1)This type of nut taps could be connected with bent shanks by         couplers, which could massively reduce

     the adjusting time before processing.

(2)Using Couplers to connect taps and bent shanks could reduce the chances of breakage from

     too much torque.

(3)We are able to design and produce nut taps which matching the couplers customer uses.

U series 5/16~1"
W series 5/16~1"
Total length within 280mm, thread length within 230mm, and pitch under 6mm.

Standard thread length: 25T

Automotive fasteners,
wind industry,
fasteners,
nuts processing
…and so on.

Cutting speed
(m/min)

Low carbon steel nut
C0.25%(soft material)

C0.25%(soft material)