MTWINC1500

                                        Description

The MTWINC1500-MR210PA is a low-power consumption 802.11 b/g/n IoT (Internet of Things) module which is specifically optimized for low power IoT applications. The highly integrated module featuressmall form factor (21.5mm x 14.5mm x3.4mm) while fully integrating Power Amplifier, LNA, Switch, Power Management, and PCB antenna. With seamless roaming capabilities and advanced security, it could be interoperable with various vendors’ 802.11b/g/n Access Points in wireless LAN. The moduleprovides SPI andUART to interfaceto host controller.

                                          Features

• IEEE® 802.11 b/g/n 20MHz (1x1) solution
• Single spatial streamin 2.4GHz ISM band
• Integrated PA and T/R Switch
• Integrated PCB antenna
• SuperiorSensitivity and Range via advanced PHY signal processing
• Advanced Equalization and Channel Estimation
• Advanced Carrier and Timing Synchronization
• Wi-Fi Direct and Soft-AP support
• SupportsIEEE 802.11 WEP, WPA, WPA2 Security
• Supports China WAPI security
• Superior MAC throughputvia hardware accelerated two-level A-MSDU/A-MPDU frame aggregation and block acknowledgement
• On-chip memory management engine to reducehost load
• SPI, UART, and I2C host interfaces
• 2- or 3-wire Bluetooth® coexistenceinterface
• Operating temperature range of -40°C to +85°C
• I/O operating voltage of 2.7Vto 3.6V
• Integrated Flash memory for systemsoftware
• Power Save Modes

–    4µADeep Power Down mode typical @3.3V I/O

–    850µADoze mode (Chip settings are preserved. Used for beacon monitoring mode)1

1See Power Consumption formodule power modes.