car escape hammers safety emergency hammer with LED light escape tools

Specifications

car safety hammer bus safety hammer auto safety hammer
-Flash warning
-Phone Charger
-Good design
-TUV

Car escape hammers Safety emergency hammer with LED light escape tools

 

 Working principle:This product adopts the principle of three-phase alternating generator to crank for power which after commutating and filtering to charge its inner 80mAh/3.6v NI-MH chargeable battery. The electricity in the battery can be used for lighting and charging mobile phone.

 

Functions :

1.Cranking for power to charge its inner 80 mAh / 3.6v NI-MH chargeable battery which reserve electricity also.

2.Cranking for power to charge mobilephone through a connector and wire.

3. Flashing alert.

4. Breaking the glass in urgent condition.

5.Cutting the strap in emergency.

6.It adopts three-phase brushless generator to generate power with high-efficiency , low noise.

7.Convenient to use by cranking , without changing battery.

8.Complete self-assistance functions.

9.Controlled by electronic switch , long lifespan.

 

Product Pictures  

Main Technical Parameters:

 

Item	Parameter	Unit
Max. brightness of 1 LED light	60000	Mcd
Max. luminous flux of 1 LED light	3.5	Lm
Lighting time after 1 minute cranking
1 LED light	40	minute
4 Φ3LED flash	60	minute
Lighting time after being charged fully
1 LED light	5	hour
4 Φ3LEDs flash	12	hour
Flash frequency	2	HZ
Voltage Output	5	v
Max. current output	500	MA
Max. power output	2.5	W
Lifespan
LED lifetime	50000	hour
Switch lifetime	100000	times
Plastic parts lifetime	5	year
The whole unit lifetime	5	year

 

 Cautions:

1. Don’t point at eyes directly so as not to hurt the eyes.

2. Put it at the place that children can’t catch in case of hurting them.

3. Try to crank it evenly (keep rotating steadily). Cranking too slowly may reduce the current and so prolong the charging time.

4. Pay attention to the holding gesture when cranking which can protect your finger and nail from hurting.

5. In order to assure the life of the battery, you should crank no more than 3 minutes continuously on the condition that it can light, and crank less than 10 minutes continuously when it can’t light.

6. In order to prolong the lifespan of the battery, you should crank it for at least one minute once a month.