MADE IN TAIWAN EPOXY ZINC PHOSPHATE PRIMER

EPOXY ZINC PHOSPHATE PRIMER

TYPE

A two-pack, special alloy primer based on epoxy resin, hardener and special zinc phosphate pigments.

USES

Uses for galvanized steel, aluminum, alum-alloy metal and stainless steel.

CHARACTERISTICS

1. Tough film, good tensile strength and adhesion.

2. Excellent resistance to fresh and sea water.

3. Excellent resistance to chemical, solvent and oil.

4. Very fast drying and excellent adhesion.

5. Very good adhesion with galvanized steel, aluminum, alum-alloy metal

    and stainless steel.

6. Very good resistance for abrasion.

7. Excellent anti-rust function.

COLOR

Gray,Red,White

GLOSS

Flat

WEIGHT

Above 1.1kg./L (Mixture)

VISCOSITY (25℃  )

70 - 90 KU (Mixture)

DRYING TIME (25 ℃  )

Set-to-touch 2Hrs. Dry hard 17 Hrs. Fully cured 3 days.

OPTIMUM FILM THICKNESS

Wet 100μ(microns) Dry 40μ(microns)

MIXING RATIO

Base : Hardener = 5 : 1(by wt.)

POT LIFE (25℃  )

8 Hrs. (Mixture)

NON-VOLATILE CONTENT

Above 70%(Mixture)

THINNER

Epoxy Thinner

THINNING RATE

5~10%

APPLICATION METHOD

Spray, Brush, Roller.

STORAGE SHELF LIFE

Minimum 1 year under normal storage conditions.

NOTE

1.Mix base and hardener according to mixing ratio and stir thoroughly;

   allowing the induced time for 10~20 minutes before application.

2.Adhered moisture, grease, dirt, rust and corrosive salts on substrate

   must be cleaned thoroughly

3.Avoid applying the paint in rainy or humid weather,avoid applying the

   paint in rainy weather or humidity above 85% RH, particularly, a wet

   surface must be thoroughly dried.

4. All equipment must be cleaned immediately after use.

5. When used inside tanks, sufficient ventilation must be provided.