1300mm Thicknessing Sander Machine

1300mm Thicknessing Sander Machine Configuration & Parameter

Machine Configuration

1, body plate bending welding, heavy, stable, and annealed, long-term will not be deformed.

2 feed rate with variable speed control, variable speed. Table lifting adopts four-column lifting mechanism, without shaking, a small error.

3, before the belt motor with "Y / " to start the conversion time set by the time relay electrical control box.

4, lifting table, by "↓ ↑" to achieve, by the thickness of the display table shows the figures for minor displacement, lifting the motor shaft can be rotated to adjust the hand wheel.

5, the front and rear of the machine belt used photoelectric control. Before the sand roller adopts adjusting mechanism has a cylinder driven eccentric shaft, when the sand roll without work could rise.

6, feed device conveying operation by the table and rubber belt continuously variable transmission, up tight cylinder and manual adjustment mechanism, sensing automatic machine control valve in the system. Feed rate can be adjusted by adjusting the shift lever on the CVT.

7. safety device: On the control panel has an emergency stop button (latching), left and right side in the sand shelf containing two photoelectric switch; relay operation in low pressure pneumatic system pressure; equipped with disc brakes on the motor pulley to parking brake to ensure rapid emergency occurs.

8, equipped with a fault light on the control panel display, such as inadequate pressure, Belt and others have about loss of control over the process display.

9, the unique suction device, so that a better cleaning effect.

Customers need to take care of themselves with others:

1,50Hz, 380V three-phase power supply.

2,0.5MPA gas source.