ROSIM Wireless Vehicle Sensor Detector Traffic Counting for Smart Intersection Traffic Light Control System

1. Real-time Traffic Counting with LED Display Guidance

This system can be used for urban highway transportation and also used for parking lot entrance and exit to count the vehicle quantity passing over it.

 

 

 

 2.Adaptive traffic signal controlling in the Intersection

2. Traffic flow detection system

Vehicle Detection Sensor is installed in specified road, detect every vehicle passing by, and transmit the real-time information to traffic management systems  via wireless access points. The user systems can  calculate the traffic flows by analysing the data.

 

 3. Corridor management

There two vehicle detector at the entrance for detecting a coming and leaving vehicle and transmitting the information.When vehicle passed the detector will trigger the camera take a picture.

 

1. Drill a hole of 12cm diameters/10cm height

2.Fill it with cement to 1/2

3.Embedded the WVD and  finish the installation

a)  Install fast. It is only almost 6 minutes that is needed to install one wireless vehicle detector in the road, after installation, the traffic control could be released immediately;

b)  Work all-weather. Bad weather for example heavy fog, snow and rain makes no difference;

c)   No damage to the road. There’s no need to cut slots on the road surface and place cables or wires as the installation of loops, but only a tiny hole with the size Φ 120/H 100 mm, which makes WVDs become the most suitable vehicle detecting solution on the city high-way and bridges;

d)   About 10 years long life span. With high standard water proof and anti-press characteristics,  WVD wireless vehicle detector can even be used in the damaged or distorted roads where loops cannot be installed.

e)  Cost saving. You just can use the cement which is about $2 for 3-4 sensors.

f)   Easy to maintain. Unlike the loops that are easily to be damaged but difficultly to be repaired, WVD wireless vehicle detector supports firmware updating over the air. No need to re-cut the slots, no more materials needed, and all of what you need is to take almost 10 minutes for the devices wireless updating;

g)  Low operation consuming. Due to the ultra-low power design and battery supply solution, WVD wireless vehicle detector’s consumed power is very lower than any other detectors like loops, video, micro-wave etc. in the market. This appears more and more significantly to our environments;

h)  Replace loops seamlessly. The same installation position and compatible output signals makes it easily and simply to replace loops in your system directly.

 1. Rosim promise to provide customers high quality products and solution

 2.All the products support wireless updating, which makes it easily maintained.

 3.Rosim provides 24 hours on-line supports.

 4. Rosim support the Starter Kit sales for customers.

If still need any further information, welcome to visit us or contact the manager Rebecca:

Welcom to visit and feel free to contact us!