Indoor GPS signal repeaters Kit GT-RK1

• GT-RK1 is a repeater operates by receiving GPS satellite signals with an antenna located outside the building and re-radiating the signals into the indoor area or covered space where satellite signal cannot reach.
• GT-RK1 is a single point GPS repeater, one transmitting antenna transmit GPS L1 signal.
• If need extend the system, you can apply multi-system receiving antenna and sending antenna, which can support multi-system, multi-waveband satellite signal receive and transmit, so as to cover satellite signal indoor.

 Typical Application:

• For GPS products testing
  For testing the cell- phone with GPS, PND, car navigators, tracker, survey products, etc.

• For the purpose of GPS signal covering
  Car parks, lab, aviation manufacturing hangar, trade shows, Emergency-, safety vehicles, public
  transportation etc.

Specification

Topological(Under standard configuration)

 System Schematic

1. GPS Antenna(TIMING 4000) be installed on roof of the building;
2. Cable assembly RG8 fixed along the out wall, one terminator connects TIMING 4000,the another to protector at the appropriate     place. In some special environment, select PE or PVC material plastic pipe to protect the cable assembly is quite sensible;
3. Protector, Amplifier and Gain controller are fixed on the wall indoor;
4. Cable assembly KSR240 is fixed along the ceiling of the operating place;
5. Antenna GTA10 be fixed on the ceiling or crossbeam.
        According to the actual environment, you can adjust positions of some parts, which can make you the adjust, change and overhaul more easily.                         

Warranty:
1. 1years warranty for the products.
2. Please send back the defective goods which are within the warranty period, we will repair them or send you     new one for free.
3. If it is the sample or only few pcs accessories (the fee is less or around shipping fee) are damaged, please send us some pictures and video about it need to confirm your problem, then we will send you free new goods instead

GT-RK1 GPS repeater fault location and remove:

First: Check the adapter of GA30-V, whether it connects to the power supply and power-up to GA30-V as GA30-V hasn’t power light. You can test the voltage between input axis and shell, if it’s about 5V,power supply was ok,GA30-V was also works ok. Or else, check the power socket to assure the contact was ok.

Second: If it’s 5V at the input of Gain Controller, you need to check whether the fixing is steady between GAT10 and the cable.

Third: If the below two step were ok, please check the outdoor antenna Timing4000.You can screw the port which connect Timing4000 and cable(carefully screw, not unplug strongly).Notice: when screwing the cable connector, you should make sure to screw the iron pipe, maintain the antenna and cable moveless, which avoid to screw off the cable. After riving, check the voltage between axis of the cable connector and the outer shielding layer to make sure it’s 5V.If no voltage, the circuit has fault, please contact our technical support. If 5V,the antenna Timing4000 can be suspected.(In fact, this case hasn’t appear in our engineering projects.