Tunnel Hot Air Circulating Drying and Sterilizing Oven

Specifications

hot-air sterilizing and drying machine
meet GMP standard
imported PLC control
touch screen system
30 days delivery time

Brief  Introduction

    The SS-1828 tunnel hot -air circulating heating and sterilizing oven is applied for drying and sterilizing antibiotic bottles ,ampoules and infusion bottles

1. meet GMP standard

2. hot-air circulating heating mode make uniform temperature and low energy consumption

3. complete 100stage laminar flow purifying device

4. adopt PLC control and touch screen for display and operation

5. adopt advanced intelligent control device to record tempreture,air volumn and speed of network

6. reliable safety installations

7. water cooling system is optional ;it can decrease fresh air supply from the washing room and reduce the risk from the wind differential pressure imbalance ,good cooling effect.

8. Wind differential pressure auto-balance system is optional ,it can make the air flow from heating section not move and steady ,it can avoid series of trouble,such as the temperature increasing in filling room and washing room

 

Operating Theory

    The bottles are fed into tunnel oven by bottle washing machine and conveyed into preheat zone,high temperature sterilizing zone and cooling zone by a horizontal network After sterilizing and removing heat source ,the bottles are fed out of oven and into bottle filling and stoppering.High temperature sterilizing zone is a hot-air circular system,which is composed of heat-resistant blower fan, filter and dehumidifier.The purified hot-air is supplied continuously through the bottles on the network,not only achieve the requirement of heating sterilizing and removing heat source,but also the protection of 100stage laminar flow reached.The preheat section is composed of blower fan and high efficiency filter; The cooling section is a cooling system ,which is composed of blower fan,high efficiency filter and exhaust blower ,achieving the bottles cooling

and the protection of 100 stage laminar flow.

    This machine adopts PLC control and touch screen to display and operation.

    This machine is equipped with a superior digital temperature controller to control temperature;the blower fan adopts frequency conversion to control speed; the wind belt adopts stepless speed,and have fault diagnosis and trouble solutions.

 

Main Technical Parameters

Power Supply	380V, 50HZ
Gross Power	≤53KW (about 40KW for proper use)
Temperature  Adjustable Range	300ºC-500ºC
Conveyer Belt Width	600mm
Purifying Stage of Laminar Flow	100stage
Cooling  Mode	100stage vertical laminal flow cooling
Air Speed Control	frequency conversion mode
Weight	approximate  3500KG
Noise of  Single Unit	≤70dB
Dimension	4400(L)×1650(W)×2400(H) mm
Production Capacity	10ml pencilin vial 200-300pc/min