Medical Baby Digital Nipple Pacifier Thermometer

Please Read Carefully Before Use:

Bettery: DC 1.55/1.5v (SR41/LR41)

Power Consumption: 0.2mW

Battery Life: More than 200 hours of continuous operation. (Approx. 2 years if used 10 minutes per day)

Display Unit: 0.1ºC/ 0.1ºF

Measuring Range: 32.0ºC~42.9ºC (90.0ºF ~109.9 ºF). 

Less than 32ºC/ 90ºF, LoºC / LoºF Display

More than 42.9ºC/ 109.9ºF, HiºC / HiºF Display

Accuracy: ±0.1ºC(±0.2ºF) between 35ºC~42ºC (95ºF~106.0ºF), ±0.2ºC(±0.4ºF) for remainder of range at room temperature of 22ºC (71.6ºF)

Dimensions: 48mm x 55mm x 36mm

Weight: Approx. 15g (including battery)

Nipple Size: Medium

Caution

1. Any pacifier wears out. TO PREVENT POSSIBLE CHOKING HAZARD, test the strength of the nipple by pulling on the bulb portion before each use.
2. Do not bend or temper with the probe and the Thermometer.
3. Do not store the Thermometer under direct sunlight or at high temperature area.
4. Temperature should be taken under adult supervision. Do not let children play with the Thermometer.  
5. When the battery is almost exhausted, the symbol ( ) will appear in the display window, meaning that the Thermometer needs to be replaced.
6. Oral temperature readings are GENERALLY 0.5°C (1.0°F) lower than actual body temperature readings.
7. This Thermometer is designed for use with the Pacifier only. Do not use this Thermometer for any measurements other than explained in this instruction.
8. Components may be harmful if swallowed. Contact your physician immediately should this occur.
9. The Pacifier Nipple comes in one size intended to fit all mouth sizes. Please gauge your child's mouth size and the nipple size prior to thermometer use. A child using a nipple that is too large has an increase risk of choking.

CARE INSTRUCTION:

1. Inspect the pacifier before and after each use.  Throw away the pacifier if any sign of worn, damaged or punctured by biting is shown.
2. Install the Thermometer only when temperature taking is needed. Remove and store the Thermometer out of reach of children.
3. Do not boil or wash the Thermometer.
4. Wash and sanitize the pacifier only by washing in hot water with gentle detergent, rinse thoroughly and boil in and open pan of water for 2 minutes.

How to Operate

1. Install and check that the Thermometer is secured into the Pacifier. If not, follow the installation instruction below.
2. Press the ON/OFF button and the display will read "188.8E", confirming that the display is working.
3. Upon releasing the on-off button, last measured temperature will be showed for about two seconds with letter “M” under the degree sign, then 37.0ºC/98.6ºF, and then LoºC/LoºF displayed (if the room temperature is greater than 32ºC/ 90ºF, it will be displayed rather than LoºC/ LoºF). The flash ºC/ºF indicates the thermometer is ready to take a temperature.
4. Position the pacifier bulb into baby's mouth as normal pacifier.
5. Note: Drinking or eating prior to use may affect the reading. Measurement should be taken one and half hours after eating or drinking.
6. After the degree sign (°C or °F) on the display has stopped flashing (approx. 3 minutes), the alarm will sound Bi—Bi—Bi.  If temperature exceeds 37.8ºC/100ºF, it sounds Bi-Bi-Bi ---Bi-Bi-Bi. It represents that the Pacifier Thermometer has detected the baby’s temperature and the reading is reflecting the baby’s oral temperature.
7. It is recommended to leave the thermometer in baby's mouth for 6- 8 minutes to allow the pacifier nipple to warm up and to get more accurate reading. 
8. The Thermometer will automatically turn off in 10 minutes. However, to prolong battery life. It is recommended to press the ON/OFF button to turn it off after each use.
9. Repeat operation procedures if interrupted during use.

TO DETACH THE THERMOMETER

1. While holding the pacifier shield with one hand, rotate the Thermometer counterclockwise until the pointer is pointing to “Open” or “Unlock” position.  (LCD display unit is vertical, 90°C, from the pacifier.)
2. Pull the Thermometer straight up until the probe is totally removed from the pacifier.
3. Do not bend or temper with the probe or the Thermometer.

TO INSTALL THE THERMOMETER

1. While holding the pacifier shield with one hand, insert the probe and shaft into the hole at the back of the pacifier.
2. Rotate the Thermometer clockwise until you feel the snap. (LCD display unit should be horizontal to the pacifier and the pointer is pointing to the “Close” or “Lock” position.)

Patents:

USA 5,743,647

GERMANY 297 22 903.6

FRANCE 2 773 216

ITALY 00238148

TAIWAN 152115

CHINA ZL 97 2 48791.3