Home > Products > Z-wave Sensors > Home use PIR sensor for smart home system
Home use PIR sensor for smart home system
- 1000 Piece / Pieces per Month
- Shenzhen
- T/T L/C D/P D/A Credit Card PayPal
Product Details
Place of Origin: | Guangdong, China | Brand Name: | EVA LOGIK | Model Number: | ZW112 |
Product Description
Introduction
This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave enabled network. Every mains powered Z-Wave enabled device acts as a signal repeater and multiple devices result in more possible transmission routes which helps eliminate “RF dead-spots”.
Technical data
*Operation Range: 8m
*360/ 110 of view,1200 Horizontal Angle Coverage
*Low battery detection
*Tamper Switch
*Range: 30m line of sight
*Operating temp: -15oC~40oC
*Working Voltage: 3V
* Battery: CR123A *1pc
*Dimensions: 91.5*61.5*48MM
*Frequency:868.4MHz/865.2MHz/869.2MHz/908.4MHz/921.4MHz
Installation
1. Release cover tab to open the cover.
2. Insert a CR123A battery into the battery compartment, and LED will start to flash slowly, which means the sensor has not yet been “inclusion”.
3. Close the cover back to sensor.
4. For “Add” in (adding to): Put the Z-Wave Interface Controller into “Add” mode, and following its instruction to add the ZW112 to your controller. To get in the “Add” mode, the distance between sensor and controller is suggested to be in one meter. Press the learn switch of ZW112 once. The LED on the ZW112 should stop flashing, if not, please try again. For “Remove” from (removing from) a network: Put the Z-Wave Interface Controller into “Remove” mode, and following its instruction to delete the ZW112 to your controller. Press the learn switch of ZW112 once to be excluded. The LED on the ZW112 should start to flash. For “Group”: removing the cover of the ZW112 to get into “Awake” mode, then put the Z-Wave Interface Controller into “Group”, and following its instruction to associate the ZW112 with other device. Close the cover back after “Group” done, afterward the ZW112 will get into “Sleep” mode for power saving. Support one association group (5 nodes). Note: ”Awake” mode: it is to leave the “Sleep” mode by removing the cover of ZW112, to allow the Z-Wave Interface Controller to do “Group.
5. Using gum wall plug & screws to mount ZW112 at 2 meters above surface. To enhance proper operation, place ZW112 on the angle which can detect the room widely. The solid area means the detector’s coverage range.
Safety and maintenance instruction
- Make sure that all electric connections and connection cables meet the pertaining regulations and are in conformity with the operating instruction.
- Do not overload electrical outlets or extension cords, fire or electric shocks can be the result.
- Please contact an expert in case you have any doubts about the mode of operation, the safety or connecting the appliances.
- Keep all parts away from young children’s reach.
- Do not store this item on wet, very cold or warm places, this can damage the electronic circuit boards.
- Avoid dropping or shocks, this can damage the electronic boards.
- Never replace damaged power cables yourself! In such case, remove them from the net and take the devices to a workshop.
- Wireless system are subject to interference from cordless phones, microwaves, and other wireless devices during installation and operation.
Maintenance
The devices are maintenance-free, so never open them. The guarantee becomes void when you open the appliance. Only clean the outside of the devices with a soft, dry cloth or a brush. Prior to cleaning, remove the devices from all voltage sources.
NOTE
Do not use any carboxylic cleaning agents or petrol, alcohol or similar. These will attack the surface of devices. Besides, the vapors are hazardous to your health and explosive. Do not use any sharp edged tools, screw drivers, metal brushes or similar for cleaning.
Warranty 1 year
Contact Us
- Dongguan NIE Technology Co., Ltd.
- Contact nameWinnie Wen
- Phone0086-769-33379207
- AddressThird Floor, Building B, Licheng Industry City, Zhendi Village, Xinan Community, Changan Town
- CG6060/32-4TE1 Communication module Realize automatic control of equipment
- IS220PDIIH1B 336A5026ADP1 Thermocouple input module
- PPC380AE01 HIEE300885R0001 Input module
- IS220PAICH2A Analog input/output module Detects external switching input
- DS200TCEAG1ACB Communication module Support data reading
- IC698CRE030 Built-in Ethernet port Automatic induction switch
- CP451-50 Processor module
- IC698CRE040-HN CPU module microprocessor
- Supports 4G Communication Power Grids Automation Industrial IoT Protocol Gateway
- DLT645 IEC104 to MQTT Power Grid IoT Gateway for Data Collection and Transparent Transmission
- RJ45 Ethernet Port DLT645 IEC104 to OPC UA Grid Protocol Converter
- Support SNMP V1/V2 DLT645 IEC104 to Modbus Distribution Protocol Gateway
- MU-TAMT02 HONEYWELL BATTERY EXTENSION MODULE
- 204-450-000-002 IQS452 Meggitt Vibro-Meter New in stock
- 204-450-000-001 IQS452 Meggitt Vibro-Meter New in stock
- TK-PPD011 HONEYWELL Battery Extension Module
- KJ3204X1-BA1 Emerson DeltaV Module High-Side Series 2 Card
- SD-98790 HARRIS Digital Input Board
- 204-677-000-003 TFM677 Meggitt Vibro-Meter New in stock
- Intelligent Power Industry Protocol Gateway for Energy Management Systems and Automation Systems
- Modbus to IEC104 Air Conditioning Protocol Gateway for Intelligent Air Conditioning Systems
- PLC to IEC104 Substation Automation Protocol Gateway for Remote Monitoring
- Power Protocol Gateway with Ethernet Port and RS-232/485 Serial Port
- Energy Gateway with WiFi or Ethernet Port for Internet Access
Popular Searches
- lightning conductor
- Copper Lightning Rod
- earthing system
- transmission rod
- 11 kv lightning arrester
- Copper Clad Steel Ground Rod
- static eliminator
- anti static device
- lightning connector
- plasma tv lift
- mtl safety barrier
- copper earthing bar
- copper earthing rods
- electrical earth rod
- earthing material
- Clad Steel Ground Rod
Recommended Products
- HAWKER Forklift Battery 48V 4PzS440 Hawker AGV Car Battery 440AH Traction
- Dutch Victron Energy Charger Phoenix Charger 24/16 Bulk Float Storage
- E-T-A 413 series: single pole high-performance thermal circuit breaker
- ER18505 4000mAh A Battery LiSOCl2 battery
- ER14505 LiSOCl2 battery 2700mAh 3.6V AA ER14505M ER14505H
- ER26500 8500mAh LiSOCL2 Battery
- ER34615 19000mah LiSOCL2 Battery 3.6V Battery
- ER14250 1200mAh 3.6V Li-SOCl2 Battery with wire lead and connector
- 50A 125/250V RV Surge Protector
- SJTW 16-14AWG*3C NEMA5-15P Power Stake
- Mechanical Timer
- RV Current Adaptor
Find Similar Products By Category
- Electrical Equipment & Supplies > Other Electrical Equipment
- Buy on GoldSupplier.com
- How to Buy
- Browse by Catagories
- Browse by Hot Regoins
- Private Sourcing Events
- Sell on GoldSupplier.com
- How to Sell
- Post Products
- Manage Products
- Manage Groups
- Services
- Latest Sourcing Requests
- Product Update
- Companies of Today
- GoldSupplier.com Mobile Site
- B2B Articles
- About
- About Us
- Link to Us
- Contact Us
- Sitemap
- Please Enter your Email Address
- Please enter the content for your inquiry.
We will find the most reliable suppliers for you according to your description.
Send Now-
Winnie Wen
Welcome to my shop! Glad to serve you!Please send your question!
Your message has exceeded the limit.
Your message has exceeded the limit.
-
-
Your inquiry content must be between 20 to 5000 characters.Send Now.
-
Please input the mailbox.
-