Home > Products > Z-wave Sensors > Z-wave Infrared Sensor
Z-wave Infrared Sensor
- 1000 Piece / Pieces per Month
- Shenzhen
- T/T L/C D/P D/A Credit Card PayPal
Product Details
Place of Origin: | Guangdong, China | Brand Name: | EVA LOGIK | Model Number: | ZW112 |
Product Description
Introduction
This sensor is a Z-Wave enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave enabled network. Every mains powered Z-Wave enabled device acts as a signal repeater and multiple devices result in more possible transmission routes which helps eliminate “RF dead-spots”.
Technical data
*Operation Range: 8m
*360/ 110 of view,1200 Horizontal Angle Coverage
*Low battery detection
*Tamper Switch
*Range: 30m line of sight
*Operating temp: -15oC~40oC
*Working Voltage: 3V
* Battery: CR123A *1pc
*Dimensions: 91.5*61.5*48MM
*Frequency:868.4MHz/865.2MHz/869.2MHz/908.4MHz/921.4MHz
Installation
1. Release cover tab to open the cover.
2. Insert a CR123A battery into the battery compartment, and LED will start to flash slowly, which means the sensor has not yet been “inclusion”.
3. Close the cover back to sensor.
4. For “Add” in (adding to): Put the Z-Wave Interface Controller into “Add” mode, and following its instruction to add the ZW112 to your controller. To get in the “Add” mode, the distance between sensor and controller is suggested to be in one meter. Press the learn switch of ZW112 once. The LED on the ZW112 should stop flashing, if not, please try again. For “Remove” from (removing from) a network: Put the Z-Wave Interface Controller into “Remove” mode, and following its instruction to delete the ZW112 to your controller. Press the learn switch of ZW112 once to be excluded. The LED on the ZW112 should start to flash. For “Group”: removing the cover of the ZW112 to get into “Awake” mode, then put the Z-Wave Interface Controller into “Group”, and following its instruction to associate the ZW112 with other device. Close the cover back after “Group” done, afterward the ZW112 will get into “Sleep” mode for power saving. Support one association group (5 nodes). Note: ”Awake” mode: it is to leave the “Sleep” mode by removing the cover of ZW112, to allow the Z-Wave Interface Controller to do “Group.
5. Using gum wall plug & screws to mount ZW112 at 2 meters above surface. To enhance proper operation, place ZW112 on the angle which can detect the room widely. The solid area means the detector’s coverage range.
Safety and maintenance instruction
- Make sure that all electric connections and connection cables meet the pertaining regulations and are in conformity with the operating instruction.
- Do not overload electrical outlets or extension cords, fire or electric shocks can be the result.
- Please contact an expert in case you have any doubts about the mode of operation, the safety or connecting the appliances.
- Keep all parts away from young children’s reach.
- Do not store this item on wet, very cold or warm places, this can damage the electronic circuit boards.
- Avoid dropping or shocks, this can damage the electronic boards.
- Never replace damaged power cables yourself! In such case, remove them from the net and take the devices to a workshop.
- Wireless system are subject to interference from cordless phones, microwaves, and other wireless devices during installation and operation.
Maintenance
The devices are maintenance-free, so never open them. The guarantee becomes void when you open the appliance. Only clean the outside of the devices with a soft, dry cloth or a brush. Prior to cleaning, remove the devices from all voltage sources.
NOTE
Do not use any carboxylic cleaning agents or petrol, alcohol or similar. These will attack the surface of devices. Besides, the vapors are hazardous to your health and explosive. Do not use any sharp edged tools, screw drivers, metal brushes or similar for cleaning.
Warranty 1 year
Contact Us
- Dongguan NIE Technology Co., Ltd.
- Contact nameWinnie Wen
- Phone0086-769-33379207
- AddressThird Floor, Building B, Licheng Industry City, Zhendi Village, Xinan Community, Changan Town
- For Building Data Acquisition HVAC Monitoring and Control BACnet/IP IO Module
- Supports VPN and TLS/SSL Data Encryption Flexible EdgeIO Controller
- 800PP846A Operation panel Provides greater visibility into the process
- TRICONEX 3721 Communication module Multiple sensors can be connected
- PM150V08 3BSE009598R1 High performance processor module Multiple control tasks can be handled simultaneously
- MS-NAE5510-3 Ethernet-based monitoring devices Higher data transfer rate
- triconex 3625C1 Digital output module The flexibility of the control system is improved
- triconex 3636R Automatic control module Supports multiple communication protocols
- KUC711AE101 3BHB004661R0101 Digital input module Ability to detect input signals in time
- CI541V1 3BSE014666R1 Interface module Connect and transfer data
- IS220PDIAH1B Turbine control PCB board
- UTV-F2500HA Manipulator controller Remote manipulator
- triconex 4329 Network communication module Ethernet (802.3) port
- Programmable Logic Controller MQTT IO Module for Distributed Data Acquisition and Control Systems
- IS215UCVEH2AB Standard mark VI controller Ethernet cable
- DS200SIOBH1ACA I/O control board There are 6 switches in each block
- DS200SIOBH1AAA I/O control board Equipped with an LED
- DS200SIOBH1ABA I/O control board Has 20 jumpers
- PP881 3BSE092978R1 Touch display module Ability to respond quickly to user operations
- IC697CPX928 Central processing unit Single slot chassis
- IS200TREGH1BEC Emergency turbine protection plate Provides negative electrode function
- F8627X Spare parts module
- SC520M 3BSE016237R1 Industrial automation module Realize automatic control of production line
- 5SHY3545L0009 3BHB013085R0001 Industrial control spare parts module The low-pass voltage drop of thyristor is realized
Popular Searches
- lightning conductor
- Copper Lightning Rod
- earthing system
- transmission rod
- 11 kv lightning arrester
- Copper Clad Steel Ground Rod
- static eliminator
- anti static device
- lightning connector
- plasma tv lift
- mtl safety barrier
- copper earthing bar
- copper earthing rods
- electrical earth rod
- earthing material
- Clad Steel Ground Rod
Recommended Products
- 6.5kw ~ 1000kw Stamford AC 3phase Electric Alternator for Diesel Gensets
- 280kw to 2000kw Diesel Power Electric Generator Powered by Baudouin for Industrial Use
- 26700 3.2V 4000mAh 4500mah 5000mAh 6000mAh Lithium Iron Phosphate Battery
- SAFRAN CIRCUIT BREAKER 4200 series
- SAFRAN CIRCUIT BREAKER 160 series
- For Building Data Acquisition HVAC Monitoring and Control BACnet/IP IO Module
- Supports VPN and TLS/SSL Data Encryption Flexible EdgeIO Controller
- AXON Radio frequency coaxial connector
- 800PP846A Operation panel Provides greater visibility into the process
- TRICONEX 3721 Communication module Multiple sensors can be connected
- PM150V08 3BSE009598R1 High performance processor module Multiple control tasks can be handled simultaneously
- MS-NAE5510-3 Ethernet-based monitoring devices Higher data transfer rate
Find Similar Products By Category
- Electrical Equipment & Supplies > Other Electrical Equipment
- Buy on GoldSupplier.com
- How to Buy
- Browse by Catagories
- Browse by Hot Regoins
- Private Sourcing Events
- Sell on GoldSupplier.com
- How to Sell
- Post Products
- Manage Products
- Manage Groups
- Services
- Latest Sourcing Requests
- Product Update
- Companies of Today
- GoldSupplier.com Mobile Site
- B2B Articles
- About
- About Us
- Link to Us
- Contact Us
- Sitemap
- Please Enter your Email Address
- Please enter the content for your inquiry.
We will find the most reliable suppliers for you according to your description.
Send Now-
Winnie Wen
Welcome to my shop! Glad to serve you!Please send your question!
Your message has exceeded the limit.
Your message has exceeded the limit.
-
-
Your inquiry content must be between 20 to 5000 characters.Send Now.
-
Please input the mailbox.
-