FS-7842 Automative A/C Hose Crimping Tools for Repair Air Conditioner Pipes

REPLACEMENT PARTS:

PRE-OPERATION SET-UP

Open the relief valve to fully recess the piston, and then close tightly.

Rotate the yoke fully counter clock-wise to bottom out the adapter seat.

OPERATING INSTRUCTIONS

Warning: DO NOT actuate the piston without having a hose and fitting in place to crimp. This could damage the tool Also be careful not to place hands near any pinch points while using the tools.

*Remove pin and open top yoke.

 NOTE: It may be necessary to turn the body counter clock-wise until top yoke can be rotated away from piston.

*Select correct die set:

 Standard Hose             Reduced Barrier Hose

#6(5/16”)-Purple         #6(5/16”)-Black

#8(13/32”)-Red          #8(13/32”)-Purple

#10(1/2”)-Yellow        #10(1/2”)-Orange

#12(5/8”)-Green          #12(5/8”)-Blue

NOTE: Be sure to correct size die set! Failure to do so could cause leakage or failure of the crimp!

*Insert dies into yoke.

*Position fitting and hose in crimper and close top yoke.

*Insert pin securely.

Note: Make sure pin snaps securely into place before crimping process is started

*Turn body of tool clockwise until dies are snug against hose fitting.

*Turn hydraulic value to CLOSED position.

*Pump handles to crimp fitting onto hose. Continue pumping until handle comes to a stop.

Note: Place the body of the tool against a solid body to create more leverage during the crimping process.

*Once crimp is complete, turn hydraulic valve to OPEN position.

*Turn body of tool counter clockwise until top yoke can be rotated away from piston portion of yoke.

*Remove holding pin and open yoke.

*Remove hose assembly.