Kiln dry of sand/sludge machine china dryers equipments factory hot selling

Kiln dry of sand/sludge machine china dryers equipments factory hot selling

Features of Kiln dry of sand/sludge machine china dryers equipments factory hot selling

1, Strong anti-overload ability, large capacity, low fuel consumption, low drying costs. 

2, Adopts downstream drying method, the smoke and wet material enter the dryer from the same side. Make use of high temperature flue gas to get high evaporation intensity. The outlet temperature of dryer is low, high thermal efficiency. 

3, Operating parameters can be changed depending on different material properties, which makes the material to form a stable full section materials curtain in the dryer drum, thus the quality and heat exchange can be better; 

4, New feeding and nesting devices which can put an end to the phenomena such as blockage, discontinuous, uneven of material feeding of the rotary dryer, as well as the recycles of material, reduces the load of dust removal system. 

5, New internal structure which can strengthen the cleaning and heat transfer for scattered material, eliminate the adhesion phenomenon of cylinder wall, and it is more adaptable to materials which are moisture or sticky. 

6, The dryer achieves the "zero level thrust", which could greatly reducing the abrasion of block riding wheel, then the cylinder could run smoothly and reliably. 

7, Adopts "self-aligning roller-type device", the mating roller can contact with the rolling ring forever linearly, thereby the wear and power loss can be greatly reduced. 

8, Control the particle size and moisture of the products according to customers’ requirements. Coal drying moisture can be reduced to under 8%, particle size can be controlled within 8mm.

Working principle of Kiln dry of sand/sludge machine china dryers equipments factory hot selling

The rotary sand dryer and sludge drying drum for sale is consist of heating device, feeding device, transport device, discharge device, dust extraction device and other connecting parts. For the installation process, the rotary drum dryer should slopes slightly so that the discharge end is lower than the material feed end in order to convey the material through the rotary drum dryer under gravity. Material to be dried enters the rotary drum dryer, and as the rotary drum dryer rotates, the material is lifted up by a series of internal fins lining the inner wall of the rotary drum dryer. When the material gets high enough to roll back off the fins, it falls back down to the bottom of the rotary drum dryer, passing through the hot gas stream as it falls. 

Here is the flow chart of Kiln dry of sand/sludge machine china dryers equipments factory hot selling

Dryer Specifications

Technical parameter of Kiln dry of sand/sludge machine china dryers equipments factory hot selling

Suitable material for Kiln dry of sand/sludge machine china dryers equipments factory hot selling

Your demands about rotary sand dryer and sludge drying drum for sale can be fully considered. Welcome to contact us or visit our factory. 

We have got certification of ISO1400:400 and ISO9001:2008, more than 60 on biomass fuel, 2 research achievement and science & technology award and 1 national innovation funding.

Our service:                                      

1.We are professional manufacturer and have more than 20 years experience as well as engaged in dryer/drying equipment/driers/drying machine.

2.we are responsible for users’ site planning, process design, equipment installation and operation training. And our engineer is available to go overseas install dryer/drying equipment/driers/drying machine for you.

3.warranty:one year for drying waste medicine dregs automatic roller dryer equipment, and long-term supply of parts