High Quality Bubble-free White Glue Self-adhesive Vinyl Film/Vehicle Wrap

Characteristics:
• This Self-Adhesive Vinyl use the white glue. and the  performation of coverage is well.
• The surface film has the good performance of the ink obsorbing, can be applied to a wide range of inkjet printers.
• Use the removable glue, to ensure the cleanliness of the bottom paper and facilitate to the second use

 Usage:


used for the wide format digital printing indoor and outdoor, the eco solvent printing and screen printing, mainly used in advertising of the windows of the buses, taxis, subway and other means of transport, glass wall advertising, windows of shopping mall advertising.

Large-format vehicle pasters/advertisement stickers are widely used.



Dry paste method

The procedures and tools: clean rags, flake flattener
• Clean the vehicle and keep it dry.
• Strip off the transfer film (the transparent film which is pasted on the vehicle paster) and the vehicle paster together; in general situations, please simultaneously paste the sticker, flatten and stripping the release paper.
• If the length and width of pasting area are less than 10 centimeters, you can paste after stripping off the transparent transfer film and sticker, but must pay attention on the unexpected adhesion or dust due to falling down.
• Forcibly and obliquely flatten with a clean rag or flake flattener for several times until the paster has no any bubbles, then remove the transparent transfer film.

We suggest not to solarize or wash within 24 hours.

Wet pasting method: it is suitable for wrapping  large vehicles (two-person working together  is recommended)

The procedures and tools: water sprayer, clean rag, flake flattener, snap-Off Knife, blow dryer
• After the vehicle body is cleaned, spray water on the area you paste with the paster by water sprayer– which is mainly used to reduce viscosity of the paster, and facilitate the position adjustment.
• Once the pasting position is confirmed, strip up the paster along with the transfer film (the transparent film which is adhered on the Reflective wrapper), from right to left (or top to bottom), press and flatten them onto the vehicle body with rag, at the same time, peel off the release paper..
• Regarding to the handle or the bumper strip, cut off or enfold the paster according to the circumstance.
• Timely adjust the position of the graphics, repeatedly scrape off the bubbles and water with flake flattener from right to left in an oblique way after the position of the graphics is confirmed, and finally remove the transparent transfer film.
• Cut off when coming to the door and joint with snap-Off Knife, and paste the paster inwards wherever possible.
• Dry the water underneath the paster as much as possible, and use the blow dryer to heat moderately if the condition allows.

Suggestion: We suggest neither to solarize the vehicle within 24 hours, nor to wash it within 48 hours as far as possible.