Bottling Conveyor Belt

NO

Technical requirement

2.1

PLC full automatic control

2.2

Adopts helical turbine reduction motor, all motors are variable frequency speed motor IP55, insulation level: F

2.3

Electric closet uses spray carbon steel material and meets IP54 function. The material is suitable for sealing completely. The main line should enter in from the below of the electric closet. 3 phase + midline + landlines. Above the ground 150 mm.

2.4

All the motors adopt 2.5 mm four core cable, using gray blue line 0.5 mm

2.5

All wires go into the motor through trunking which is made of 1.2 mm 304 stainless steel

2.6

The installation of trunking is higher than conveying chain below

2.7

Wire qualification slots, through 20 mm stainless steel tube connects motor sensor, connect the sensor joint rapid joint, can not directly bound docking. Transmission line or switch fuse must be of the waterproof connector

2.8

All the electrical components to have marking, the line number

2.9

No single part in changing the pressure set separate start stop reset switch.

2.10

The whole line in personnel accessible area (the operator) to arrange a sudden stop switch, alarm lamp. Electricity installation party on 3 association-like signal lamp, and high alarm (85 dB above), must achieve fault alarm

2.11

The cupboard door should paste English marked electricity safety tips logo.