metal automatic polishing machine

Plasma polishing (EDTM) machine Main features:
(1) Depending on the size of the workpiece, the workpiece can reach nearly mirror-polishing effect within tens of seconds to two minutes, so that subsequent processing is very convenient;
(2) effectively removed during polishing, stamping or other manufacture of the corner member burr;
(3) a polishing process, to produce a layer of the surface passivation film, to keep the light durability, enhanced corrosion resistance of the polished surface;
(4) polishing uniformity of location, or even the entire surface of the workpiece can reach all parts of the dead nearly identical mirror effect;
(5) is controlled by the electrical parameters of the polishing process, the whole process imported PLC automatic control, simple operation, easy maintenance;
High (6) efficiency and low production cost;
(7) chemical polishing process does not produce pollution
(8) ability to clean: Before EDTM system not only positioned as a quick polish outside agencies, but also suitable for a variety of shapes alloy surface decontamination, degreasing, go to the oxide layer, cleaning residual impurities and chemicals, surface coating provides the most high-quality pre-processing.

1. Apply to deburr the hard internal burrs. It can form a small circle in  cross holes or edges.

 2.Apply to the heat-treated and high-processed components, protecting the refined surface.

 3.Apply to the  production line , suitable to several pieces deburring at the same time.

 4.Appliy to the whole metal cutting processing fields.

 5.High effectiveness, only 2 or 3 seconds per working cycle. 

 6.Economical in medium or large production lot.

 7.No harm to human .