smart car parking lift system/2 post both level carport/galvanized two post duplex parking equip

Specifications

two post car parking lift
lifting capacty 2700kgs
adjusting lifting height 0~~2100mm
cylinder reversal
layser cutting

Common faults and maintenance methods:

 

Questions	Reasons	Solutions
The platform doesn’t rise ,Motor turns, no leakage of hydraulic oil	Air in the hydraulic oil	Non-load lifting to the apex ,need keeping some seconds then falling, stopped when falling to the middle, opened the oil connection to exhaust, then tighten.
	Low temperature made the hydraulic oil thickened	Anew replenish hydraulic oil
	Overloaded	Check and confirm the lifting weight is less than the rated load
Leakage hydraulic oil in the place of tubing joint	Joint loose	Screw down
	Joint was broken	Replace joint
Leakage hydraulic oil	Oil cylinder sealing ring was wear	Replace the oil cylinder and sealing ring
Motor do not turn	Motor burn out	Check and replace the motor
	The voltage is too low	Check and confirm the voltage for voltage regulation
	The fuse is bad	Replace fuse
	Limit switch is broken	Replace limit switch
Platform is not falling	Platform in the lock state	Control the platform rise and unlock, then control it falling
	The hydraulic oil is too thick	Replace hydraulic oil

 

 

  

2 post car parking lift

 

Drawing:

 

Specifications

 

Name	Two Post Parking Lift
Model	PTJ 201-27
Dimension	4529*2560*3500mm
Weight of parking car	2700kg/ 5947lbs
Rated speed	2m/min
Lifting height	2100mm
Total height	3500mm
Size of vehicle loading pallet	4166*2100mm
Motor	2.2kw
Warming devices	Yes
Mode of operate	Button / IC card / Remote key
Mode of control	PLC control
Mode of drive	Hydraulic driving, chain balance
Electrics motor	380v,3 phase; 220v single phase (by ordered)
Net weight	1150kgs

Advantage of PTJ 201-27

1. Protective device

a. anti-dropping device: to prevent the vehicle loading pallet from undersired disconnection

b. limited switch device: to prevent the equipment running

c. photoelectric switch (device for checking the entrance of people and vehicles): to prevent the people from accidently entering into the equipment under operation.

d. emergency switch: the emergency switch button is used to cut power off when there is anything abnormal during the equipment process.

     2 .Oil cylinder

Used cylinder reversal, have many advantages, not distortion, dustproof.

Adopt Italy Aston Seal ring.

   3. Adjusting lifting height, the maximum lifting height can be 2200mm. Usually, lifting height is 1900mm, 2000mm or 2100mm.

   4.  Lifting capacity can be 2700kgs

   5. Structure all adopts layer cutting, attractive appearance, easy installation, less questions, easy maintenance.

   6. Vehicle loading pellet is 2100mm,usually loading pallet is only 2000mm

 

Production Description:

 

This parking system is designed of two spaces of up and down as one unit. The bottom car can go in and out directly. When the upper space needs to park a car, the car in the bottom should be driven out;

 

It can be widely used in hotels, enterprises and public institutions and residential area. Column can be N+1 form, saving land area, full use of space, property rights;

 

Hydraulic drive, chain balancing device to ensure the balance both ends of rise and fall’;

 

Low noise, smooth operation, save energy, low carbon and environmental protection;

 

Vehicle loading pallet fully enclosed design, to avoid oil leakage, rain and snow

Polluting the lower vehicles;

 

Spraying plastics, high anti-corrosion ability, long life. Electrical and driving parts with waterproof characteristics;

 

Simple structure, easy installation, minimal requirements for civil engineering;