flavor of Milk Chocolate none 0mg and Irish Cream med 11mg Green Vaper's U-Rock as 20W e cig box mod Made in China

Switching between Left / Right Display Orientation

With the UROCK in the locked mode, hold the FIRE BUTTON and “+” BUTTON for five seconds simultaneously, the OLED orientation will switch between left and right modes every five seconds.  The OLED screen will display “LEFT MODE” or “RIGHT MODE” accordingly.

Vaping

Press the FIRE BUTTON to vape at the preset parameter.  In Normal Mode, the OLED screen will display the atomizer’s resistance together with other parameters.  Release the FIRE BUTTON to stop vaping.

(Note: If the UROCK is not properly connected to an atomizer, the OLED screen will display “CHECK ATOMIZER” and the unit will not fire.)

Charging

Standard charging voltage/current is 5V/500mA and the maximum charging input voltage should be less than 6V.  When connected with the provided USB cable to charge, the OLED screen displays “CHARGING” for two seconds and the battery meter will start flashing. The battery meter appears full and stops flashing when the UROCK is fully charged.

Low Power Warning

When the battery level is lower than 3.3V, the OLED screen will display “LOW VOLTAGE” and flash for five seconds. The battery meter will flash and cuts off power to protect the UROCK from overdraining the battery. Recharge the UROCK to resume use.

Vaping Overtime Protection

If the FIRE BUTTON is held down continuously for more than 15 seconds, the UROCK will cut off output as a precaution. The OLED screen displays “OVERTIME” and flashes. Release the FIRE BUTTON to reset the timer and resume vaping.

Short Circuit/Low Resistance Protection

When the atomizer has short circuited or if its resistance is lower than 0.3 ohms (not including 0.3 ohms), the VÖLUND will cut off output automatically, with the OLED flashing “OVER LOAD” as warning.

Over-temperature Protection

If the circuit board reaches a temperature of 125 degrees Celsius, the UROCK cuts off its output, the OLED displays “OVER TEMPERATURE” and flashes.  The OLED will not display the setup parameters until the temperature falls below 125 degrees Celsius.