led strip 3528 60 leds IP65

Led strip 3528 60 leds  IP65  

Features:

1: Power 3528 TOP SMD LED as lighting resources .
2: Available cool white(TC:5700-6500K) and warm white(TC:2900-3300K) .
3: Input Voltage DC 12V or 24V .
4: Can be cut by 3 LEDS (DC 12v) and 6LEDS (DC 24v ) and connected again by our accessories; With 3M adhesive tape back .
5: Can be chosen copper PCB or white PCB .
6: .Anti-oxidation, anti-UV radiation and won't change color after long time use .
7: High flexibility ,high transparence, flame-proof and environmental friendly .
8: Silicone material offers good heat or cold resistance and is not easily broken .
9: With silicone transparence waterproof connector can easily connect and totally waterproof .
10: Waterproof Material: Silicone hollow tube ,Silicone glue .

To cut and seal at one end, please follow the steps: A1 A2 A3 B1 B2
To cut and install waterproof connector at one end, please follow the steps: A1 A2 A3 C1 C2 C3 C4 C5
A1 : Cut the light strip at the mark ”scissors” or by every 3 LED's.
A2: Screw to open the glue cap.
A3: Use the thrust (another side of glue cap ) to puncture the surface .
B1: Inject the silicon gel into the end cap without holes .
B2: Push the strip into the cap and let gel dry for 1 hour.
C1: Put the connector wire through the end cap holes.
C2: Solder the wire onto the PCB .
C3: After solder the two wires, push the strip into the end cap with wires carefully.

C4 : Inject the silicon glue at the end of strip and cap .
C5: Make sure end cap and strip are connected well and let gel dry for 1 hour.
This Waterproof LED strip can be in Non-waterproof:

Note :
1,please make LED drivers compatible with waterproof high output led strips before use LED strips.
2,To use waterproof high output led strips 5M in serial, longer than 5M in parallel.
3,Before use,first check the power supply used in compliance with of the power requirements.
4,Each roll ask for independent power supply;not to use of multi-volume series use.

Packing:

1) For wholesale:

5m or 10m Strip light enwind plastic roll, then put into carton with the accessories.

2) For retailer:5m, 10m on roll with controllers and cable/plugs

 Buyers pay the fee for special package (color boxes, spools)