Medical Mini Air Compressor Nebulizer

This unit is compact, simple to operate and convenient to carry. It uses a non-oil lubricating, single-cylinder piston pump to create air pressure.

Air flows through the air filter into the nebulizer’s air compressor unit, out the jet outlet, and then through the nebulizer.

1. Place compressor on a stable, sturdy and flat surface such that the unit can be easily reached when you are seated.

2. Pull out the power cord from the base of the unit and make sure that the unit is in the “OFF” (O) position by pressing on the left side of the switch.

3. Plug the power cord into a 230VAC/50Hz,220VAC/50Hz wall outlet.

4. Connect one end of the nebulizer tubing into the air outlet connector.

5. Add the prescribed medication through the opening on cap using an eyedropper or pre-measured dose container.

6. Assemble mouthpiece and T-piece and insert into the top of the nebulizer cap. If an aerosol mask is used, connect the bottom of the mask to the top of the nebulizer cap.

7. Connect the tubing to nebulizer air inlet connector.

1 User manual

1 Nebulizer set

1 Tubing

1 Adult mask

1 Pediatric mask

1 T adapter

1 Nebulizer cup

1 Reservoir tube

1 Mouthpiece

1. The filter of air compressor should be replaced when it turns grey. Additional filters can be purchased from the dealer or pharmacy that you purchased the device from.

2. A certified technician should make repairs only.

We can supply OEM service and welcome your inquiry!