AR9582 3g portable wireless wifi router low power

1.    General

The Qualcomm Atheros AR9582 is a highly integrated single-chip solution for 5 GHz

802.11n wireless local area networks (WLANs) that enables high-performance 2x2 MIMO with 2

Spatial Streams for wireless applications demanding the highest robust link quality and maximum

throughput and range. The AR9582 integrates a multi-protocol MAC, baseband processor, analogto-

digital/digital-to-analog converters (ADC/DAC), 2x2 MIMO radio transceivers, and PCI

Express interface in an all-CMOS device for low power consumption and small form-factor

applications.

The AR9582 implements half-duplex OFDM, CCK, and DSSS baseband process, supporting up to

150 Mbps for 20 MHz and 300 Mbps for 40 MHz channel operations, and IEEE 802.11a/n

data rates. Additional features include Maximal Likelihood (ML) decoding, Low-Density Parity

Check (LDPC), Maximal Ratio Combining (MRC), Tx Beamforming (TxBF), Space Time Block

Code (STBC), and On-Chip One-Time Programmable (OTP) memory. The AR9582  supports

802.11 wireless MAC protocol, 802.11i security, Rx/Tx filtering, error recovery, and 802.11e

quality of service (QoS).

The AR9582 supports up to two simultaneous traffic streams integrating two Tx and two Rx

chains for high throughput and extended coverage. Tx chains combine baseband in-phase (I) and

quadrature (Q) signals, convert them to the desired frequency, and drive the RF signal to multiple

antennas. Rx chains use an integrated architecture. The frequency synthesizer supports 1-MHz

steps to match frequencies defined by IEEE 802.11a/n specifications.

The AR9582 supports frame data transfer to and from the host using a PCIE interface providing

interrupt generation and reporting, power save, and status reporting. Other external interfaces

include EEPROM.

1.1 Features

• Dynamic frequency selection (DFS) in required 5-GHz bands when used as an AP
• 2x2 MIMO technology improves effective throughput and range over existing 802.11a/n products
• Supports spatial multiplexing, cyclic-delay diversity (CDD), low-density parity check (LDPC), maximal ratio combining (MRC), Space Time Block Code (STBC), and Tx Beamforming (TxBF)
• Smart antenna diversity
• Single-ended RF ports with integrated matching simplify board design and layout
• Integrated 1.2 V switching regulator
• Data rates of up to 150Mbps for 20 MHz channels and 300 Mbps for 40 MHz channels using reduced (short) guard interval
• On-Chip One-Time Programmable memory
• Support for IEEE 802.11e, h, and i standards
• WEP, TKIP, AES, and WAPI hardware encryption
• PCI Express 1.1 interface
• 20 and 40 MHz channelization
• High Tx power accuracy at lower power level
• 8 bits spectral analysis resolution
• Frame aggregation, block ACK
• 802.11e-compatible bursting
• Support for 2/3/4/6-wire BT coexistence

2.PRODUCT SPECIFICATIONS

Main chipset :WiFi Single Chip: Atheros AR9582

Functional Specifications

3.Temperature Limit Ratings

4.Diagram

5G  (2x2) Solution with Single Antenna

5.Electrical Characteristics

DC Characteristics

6. Electrical Specifications

1) RF Characteristics for IEEE802.11A (BW20_OFDM54)

2) RF Characteristics for IEEE802.11A (BW40_MCS7)

8.Mechanical

9.Pin definition module corresponding external Mini PCIE socket

10.Product photo