Light Weight High Quality 50,000~300,000m3/Year AAC Production Line steam boiler and autoclave for aac plant

      Light Weight High Quality 50,000~300,000m3/Year AAC Production

                 Line steam boiler and autoclave for aac plant

The brief introduction of  Steam Boiler, AAC boiler

The Steam Boiler, AAC boiler adopts traditional vertical structure, smoke tube is intensified heat transfer with thread form, and uses boiler economizer to reduce funnel temperature, improve product's efficiency and performance.

1. Vertical layout: covering small area, easy installation.

2. Using screw tube and boiler economizer with high efficiency.

3. Automatic control: Good safety performance, easy operation.

Steam Boiler, AAC boiler Features:

1 ,the output capacity is sufficient and continuous:Because of adopting the high efficiency heat transmits spiral gas tube,so the real output capacity of boiler is 10%-15% higher than rated.And either output capacity or thermal efficiency will not decline as extended the running time.

2 ,Small size,less investments:we use efficiency threaded pipe,so hot water boiler that the output water temperature ≤150°c,

with a smaller capacity steam boiler can cancel the tail heating surface.the height of boiler is less than other coal-fired horizontal steam boiler hwihc has the same boiler room will spend much less money

3,No need special protection when power off:The hot water is mixed cycle and the water capacity is large,so the special protection is no need for damage caused by vaporization when power off.

4 ,The efficiency of the boiler is higher:the spiral gas tube is placed inside the boiler,so there will be no cool air entre.This can reduce heat loss and working rate of this boiler is highest.

5 Heating fast:There many spiral gas tubes in the boiler and almost half of the boiler shell can be heated,so the temperature can up soon and the time was short than the water-tube boilers.

6 ,safe and reliable:The special structure and material make the boiler begin with high safety

7,Primordial dust emissions density is low:The volume of the boiler is large and there is a dust separation device,so the primordial dust emissions density will be controlled much lower than the standard allowed

8,Easy to install: The installation charge is little and the installation time is short

If you are interested in our Light Weight High Quality 50,000~300,000m3/Year AAC Production Line steam boiler and autoclave for aac plant, please feel free to contact with us at any time

Contact person: Rebecca Hong

 Tel : +86-371-67944555

  Fax: +86-371-67944555

  Skype:rebecca.hong321