Inspection Spreader/ Tyre inspecter KTJ

Specifications

Tyre inspection spreader is used to inspect the casing from inside to make decision wheather the trye can be retreaded.

Function:

Tyre inspection spreader is used to inspect the casing from inside to outside to evaluate the safety of the tyre and make the decision whether the tyre can be retreaded. Find and mark all visible and repairable defects on the acceptable tyres.

There are various ways of tyre initial inspection, but it boils down into three ways: visual inspection, pressure testing inspection and non-destructive inspection (shearography). We apply the Inspection spreader/ tyre inspecter KTJ to The visual inspection, and Pressure Testing Machine CQJ to the pressure testing inspection.

 

 

KTJ spreader in our factory

 

Features:

1. Easy to be lifted, for the tyre loader is driven by pneumatic cylinder.
2. Reduce the physical effort involved.
3. Applying for both inspection and repair.
4. Superior quality, durable and minimum maintenance.

Why we need to inspect before retreading?

Tyres are collected from various areas and each tyre’s condition is different. To ensure the retreading quality of every tyre, we must check the collected tyres.

Tyres are not acceptable if the following conditions happen:

1. Sidewall damage is beyond repair limits.
2. Bulges caused by separated or broken part of wires on the sidewall.
3. Wires of sidewall bruise breaks, contusion and blow outs, etc.
4. Bent, distorted, torn, burnt, broken, deformed and excessively senile beads.
5. Deep & rusty penetrated steel wire cuts which cause separation.
6. Ply separation, excessive damage and extremely large orifice around crown area.

How it works:

1. Set tyre on the inspection spreader. The tyre will be lifted to the height of appropriate operation position by pneumatic cylinder.
2. The tyre casing will be expanded to the reasonable width for easy inner inspection by the paw of inspection spreader.
3. Rotate tyre, find and mark the defects with light.

 

inspect the tire with our KTJ spreader

 

 

Specifications:

Tire size range	7.50R16~12.00R20
Dimension(mm)	1600×1300×900
Electric machine power (KW)	0.55
Power supply	AC380V/50Hz, AC220V/50Hz
Compressed air source (MPa)	0.6

The above mentioned specifications are for reference only, the actual parameters may be changed in line with the improvements of product design.