Inclined drop tester with adjustable angle

SPECIFICATION

I. Product core features

1. Angle dynamic adjustment system

Adjustment range: 0°~60° infinitely adjustable (can be customized to 90°), support horizontal slide, slope fall and other multi-scene simulation.

Precision control: Angle deviation ≤±0.5°, using servo motor drive + encoder feedback, to ensure the consistency of repeated testing.

Fast switching: Angle switching time <15 seconds (traditional manual adjustment needs to be disassembled and reassembled, which takes more than 10 minutes).

2. Innovative fall simulation mode

Inclined plane - free fall composite test:

The specimen is first accelerated along the inclined plane, and then falls freely after reaching the edge, simulating the uncontrolled scene at the end of the conveyor belt (e.g. express sorting center).

Multi-segment angle programming:

Supports segmented programming of incline angle (e.g. 10°→30°→50°) to test the cumulative damage of packages under continuous incline change.

3. Intelligent data output

Multi-dimensional parameter monitoring:

Glide acceleration (0~10m/s²)

Impact instant G value (three-axis acceleration, ±5000g)

Specimen deformation trajectory (optional high-speed camera system is required).

Inclined drop tester angle adjustable use conditions

I. Environmental conditions

Temperature: The equipment should be used in an environment between 15°C and 35°C to ensure the normal operation of mechanical parts and the stability of electronic components.

Humidity: Relative humidity should be controlled between 20% and 80% to avoid electrical failure or corrosion caused by high humidity.

Power supply: A stable AC220V/50Hz power supply is required to ensure that the equipment is not affected by voltage fluctuations during operation.

Ventilation: Good ventilation should be maintained around the equipment to avoid overheating affecting the performance of the equipment.

II. Installation conditions

Ground flatness: the equipment should be installed on a solid and flat ground, and the horizontal error should be controlled within ±5mm to ensure that the impact force is evenly distributed when falling.

Space requirements: In order to facilitate operation and maintenance, the equipment should be surrounded by sufficient space, it is recommended that at least 1 meter of space be reserved for the front, back, left and right.

Base bearing: The installation ground should have enough bearing capacity to withstand the total weight of the equipment and the maximum load.

Angle adjustment range and precision

Adjustment range: The angle adjustment range of the inclined drop tester is usually from 0° to 90°, which can meet the needs of different product drop tests.

Adjustment accuracy: The accuracy of angle adjustment should reach ±1° to ensure the accuracy of test results.

Operation conditions

Operator training: The operator should be professionally trained and familiar with the operation procedures, safety precautions and emergency handling methods of the equipment.

Warm-up time: the equipment should be warmed up for 15 to 30 minutes before use to ensure that the components reach a stable working condition.

Sample Preparation: The test samples should be prepared in accordance with the relevant standards to ensure that the size, weight and packaging status of the samples meet the test requirements.

V. Safety conditions

Protective devices: The equipment should be equipped with perfect safety protective devices, such as emergency stop button, safety light curtain, guardrail, etc., to ensure the safety of operators.

Warning signs: Set warning signs in the prominent position of the equipment to remind the operators of safety matters.

Emergency handling plan: Develop and familiarize with the handling plan in case of emergency to ensure that measures can be taken quickly in case of abnormalities or accidents in the equipment.