SG-4162AD 150MHz RF Signal Source Frequency Meter Frequency Counter Digital RF Signal Generator

SG-4162AD 150MHz RF Signal Source Frequency Meter Frequency Counter Digital RF Signal Generator 

Features:
- Frequency range: 100kHz-150MHz
- 8-digit display of internal or external frequency
- Output waveform: sine wave
- In-band and out-of-band modulation
- Frequency meter: 10Hz-150MHz

Application:
SG-4162AD function signal generator is suitable for scientific research and experiment of electronic circuits and pulse circuits.

Performance Parameters:
Output Signal:
- Frequency range: A: 100kHz-300kHz; B: 300kHz-1MHz; C: 1MHz-3.2MHz; D: 3MHz-10MHz; E: 10MHz-35MHz; F: 32MHz-150 MHz; 3rd harmonic up to 450MHz
- Frequency accuracy: ±reading accuracy ±1-digit
- Output amplitude: 100mVrms (at 35MHz)
- Amplitude control: 0dB, 20dB and fine adjustment
- Modulation: Inner: 1kHz; Outer: 50Hz-20kHz (<1Vrms)
- Audio output: 1kHz (fixed, ≥1Vrms)

Frequency Meter:
- Frequency range: Low frequency: 10Hz-10MHz; High frequency: 10MHz-150MHz
- Sensitivity: <50mV
- Input impedance: low frequency: 1MΩ; high frequency: 50Ω
- Maximum input voltage: about <3V

General Parameters:
- Power supply: AC 220V±10%, 50-60Hz (110V±10% optional)
- Working environment: 0℃ to 40℃/≤90%RH
- Size: 310 x 100 x 260mm/12.2 x 3.9 x 10.2"
- Weight: 3.8kg/8.4 lb

Package Included:
- 1 x Set of Signal Generator

Instructions For Use:
1. Ready to operate
1) The power switch is set to OFF.
2) Connect the power cord and plug it in.
3) Connect the high-frequency signal output line to the output terminal.
4) Select the frequency range and adjust the frequency knob to reach the required frequency.
5) The output line should be as short as possible to avoid absorbing unwanted noise. Long shielded lines can reduce the frequency response of high frequency bands, especially when using square waves.

2. Connection
When the signal wire is connected to the output, the red wire is high potential (or fire wire), the black wire is the ground wire and is connected to the chassis.

If high-frequency signals are to be connected to the antenna input of the receiver, a 50 to 200 Ω resistor should be connected in series. If receiving with a rod antenna, connect a coil with a few turns of wire on the test line to couple the signal to the antenna.

When detecting a high frequency and an intermediate frequency amplifying circuit, a middle to go through . 1-5pF small capacitance, in order to avoid detuning effect.

Note: When directly connecting the test circuit, make sure that there is no high DC voltage in the circuit under test. Otherwise, the frequency may be connected in series a 0.05 [mu] F. - 100pF capacitance.

Detail photo

FAQ 

Q1. Can I have a sample order?

A: Yes, we welcome sample order to test and check quality.

Q2. What about the lead time?

A: Sample ususally take within 3 working days.

Q3. Do you have any MOQ (minimum order quality)limit?

A: For standard product, usually 1pcs/item. For the OEM order, MOQ at least 50pcs/item.

Q4. How to proceed an order?

A: After buyer confirm the product&price is ok and ready to buy, order will be please tell us your delivery address, phone number, sometimes need email. Then we can draft the order and it will have a alibaba paying link.

Q5. After paid, what info of the supplier provided?

A: Tracking number

Q6: Do you offer guarantee and after-service for the products?

A: Yes, 6- 12 months warranty for our products. Note: We will do not take the responsibility for Man-made damage or improper operation. Delivery demage will be negotiate.

Packing and Shipping

Package: Normally we use the standard paper package to export worldwide.

Shipping : 

1. By Couriers: DHL, UPS, FEDEX, TNT are the main courier  we are co-operating at present.

2. By chinese small parcel, usually for the customer to save the cost. But Chinese small parcel have the risk for lost parcel. Note: If we got the parcel back, we only can refund the item cost. If we didn't get the parcel,then sorry we can't refund any.

3. By Air: Delivery from the Shenzhen airport to customers’ destination city air port.

4. By Sea: Delivery from the Shenzhen sea port .

Company information

TZT has been speciliazing in Business & Industry,Hobbies & Toys,CNC Products and Health care supplies for over 5 years.We committed to enhance customer satisfaction by continually improving the process with a vision of expertise in the field. 
Aiming to provide high quanlity products and great service for buyer,we are strict on product quanlity control and offer instant communication service.Welcome to contact us!

Our Advantages:
-  Source only the best consumer goods and ensure the highest quality.
-  Streamline the buying and payment process, and make it as easy as possible.
-  Help the customers all over the world discover products and manufacturers in China.
-  The Shortest order processed time and speed delivery