Particle filter efficiency and airflow resistance tester

Function Overview:

Filter material efficiency test bench, suitable for testing filter material efficiency of 40-99.9% grade, testing filter material according to international standard. The design of the whole test bench is compact, light, and only needs to provide appropriate power and compressed air (no water, no oil) during the operation of the test, suitable for laboratory, factory and other occasions.

Design principle

It is stipulated that particle counting method is used to measure the diameter efficiency in filter paper test. Both monodisperse and polydisperse aerosols can be used in the experiment. The difference between the two methods lies in the aerosol generation method and the particle counting method. The pressure drop shall be measured at the specified filtration rate.

The filter paper is fixed on the fixture, and the test air volume corresponds to the required filter speed. The aerosol produced by the aerosol generator is adjusted (for example, the evaporation of the solvent), then neutralized by electrostatic (DOP), mixed evenly with the filtered test air, and then into the filtration material in the test area.

To measure efficiency, one air is drawn upstream and one downstream of the filter. Using the particle counting instrument, the counting concentration of each particle size in the sampled airflow was measured, and then the measured efficiency was obtained through the ratio of upstream and downstream.

In addition, it is necessary to measure the filter resistance during the test, and manually adjust the flow control.

The machine meets the reference standards:

● Performance test Method for filters for general ventilation

● ANSI/ASHRAE52.1-1992

Test methods for air purifiers for general ventilation - weight method and colorimetric method

● Europe EN 779:2002

Air filters for general ventilation - Determination of filtration performance

● Japan JISB9908:2001

Test methods for air filters and electric air cleaners for ventilation

● European EN1822-3 high efficiency filter

●GB2626-2006 Self-priming filter respirator against particulate matter

●GB2626-2019 self-priming filter respirator against particulate matter

Low ISO - 29463

A high efficiency filter and filter medium for the removal of particulates from the air

The test efficiency ranges from 40% to 99.9%@≥0.3 m

The test area is 100cm

The test differential pressure ranges were 0-50Pa ±1% and 50-500Pa ±1.5%

Test flow rate of filter material under test: 25-100l /min±2.5%(adjustable)

The aerosol types DOP(oily) /Nacl (saline) were selected

Counter sampling flow 2.83l /min ±5%

The particle size shows @≥0.3um

Counter laser light source laser diode

The inlet air pump works steadily continuously

Counter verification standard GB/T6167-2007, JJF1190-2008

Counting repeatability relative error <±10%

Count size distribution error <±30%

Counter self-cleaning time ≤10min (counting is zero for 3 times within 10 minutes, 95% confidence)

Data memory capacity 1 ~ 1000 sets of measured data, which can be exported

The screen displays a color 7-inch touch screen

Built-in thermal printer for printing

Power supply/power AC 380V/50Hz 1KW

Dynamic detection range was 0.001-100 mg/m3 with an accuracy of 1%

Data export interface USB

Environment: 0 ~ 30℃ relative humidity 10 ~ 70%; Air circulation!

Storage environment: 0℃ ~ 30℃ Relative humidity 0 ~ 70% air circulation!

Standard accessories thermal printer paper, operating instructions, certificates