Solar panel Mechanical Load Testing equipment/PV Module withstand force deformation testing machine/PV module testing machine

Solar panel Mechanical Load Testing equipment/PV Module withstand force deformation  testing machine/PV module testing machine 

Standard

It’s conform IEC61215 2005 & 2016 ,IEC61646 and IEC TS 62872-2016 etc testing standard

Purpose

This test is to determine the ability of the module to withstand wind , snow , static or ice loads

Technical specifications

 Procedure

1.Equip the module so that the electrical continuity of the internal circuit can be monitored continuously during the test

2.Mount the module on a rigid structure using the method prescribed by the manufacturer including the mounting means (clips/clamps and any kind of fastener) and underlying support rails, if t here are different possibilities each mounting method needs to be evaluated separately , for all mounting methods , mount the module in a manner where the distance between fixing points is worst case, which is typically at the maximum distance. 3.On the front surface , gradually and uniformly apply the test load, load uniformity needs to be better than ±5% across the module with respect to the test load, maintain his load for 1h

4.Apply the same procedure as in step c to check back surface of the module or as uplift load to the front surface

5.Repeat step c and d for a total of three cycles

Site Demand

PV Module Testing machine's pictures display