IEC 61000-4-2 Isolated DC-DC Converters 13W Output 3V MT13-24S3V3-PEC

DC-DC Converters 13W Output 3V MT13-24S3V3-PEC

Key Features

Output power: 13W

Wide input range:18-36Vdc

High conversion efficiency: Up to 88%

Line regulation to ±0.5%

Load regulation to ±1.0%

Fixed operating frequency

Isolation voltage :1500V

Enable (ON/OFF) control

Output over-voltage protection

Output over-load protection

Hiccup mode short circuit protection

Over-temperature protection

Input under-voltage lock-out

Output voltage trim -5～+10 % Vout

Product Overview

These DC-DC converter modules use advanced powerprocessing, control and packaging technologies to providethe performance, flexibility, reliability and cost effectivenessof a mature power component. High frequency Active Clampswitching provides high power density with low noise andhigh efficiency.

Product’s Introduction

The MT series is an independently regulated single output converter that uses the industry nonstandard brick packagesize. Integral PCB transformer/inductor is used for all models in this series. This new design technique has greatlyimproved the magnetic coupling, reduced switching spike and provided performance consistency. It also streamlines theproduction process by completely eliminating the hand-wind magnetic assembly process from production lines.

Part Numbering — MT13‐24S3V3‐PEC

1. Electric Characteristics

Electrical characteristics apply over the full operating range of input voltage, output load and base plate temperature,unless otherwise specified. All temperatures refer to the operating temperature at the center of the base plate. All data testing at Ta=25oC except especial definition.

1.1 Absolute Maximum Ratings

1.2 Input Characteristics

1.3 Output Characteristics