Good Performance Lignite Briquette Machine

Lignitebriquette machine

1. 1.    Productintroduction:

Lignitebriquette machine (with adhesive type) mainly has the motor, reducer,mainframe, belt conveyor, the ball slot of the roller set of device, hydraulicsystem and electric control, etc. Lignite by its own gravity from the feedinlet, into two intermediate pressure and, pressure and uniformly distributedon the surface of the same shape and groove, pressure and constant speed, torotate in the opposite direction, lignite bite into the groove and forcedcompression, with pressure and continues to rotate, pressure after lignite materialball in its surface tension and gravity off ball.

1. 2.    Usecommon sense:

2. 1.No matter in what way feeding must be reliable iron removing device, otherwiseit may cause pressure and even destroy the whole major accident is arranged infront of the feeding equipment.

3. 2. Inorder to ensure the normal operation of equipment must be used, can feed thefeed material into the mechanical adjusting equipment.

4. 3.Equipment must be related to the equipment before and after the equipment tostart and stop the chain.

5. 4.After the normal operation of equipment should regularly check the connectionparts are firm.

6. 5.Replacements of bearings, should adjust the bearing radial clearance, theclearance should conform to the standard.

7. 6.Equipment fixed bearing seat and the lubrication point of the sliding bearingseat should be on time to refuel, ensure that the cavity to keep 80% of thegrease. Each time the transmission support, should ensure that the pre-pressdevice on the grease from the shaft end of the squeeze out (the purpose is toremove the dust material into the damaged bearing).

8. 7.Hydraulic oil pump, oil filter should be cleaned after a month. Effectiveworking period of 3-6 months after the mail should be cleaned, the replacementof a stand of the winter environment temperature of not less than 5 degreesCelsius.

1. 3.    Productconfiguration:

2. 1.    Chinesemaximum pressure ball machine manufacturers. And magnesium powder;

3. 2.    Toprovide 520-1200mm roller by a full set of products;

4. 3.    Forcedpre-press output 11T/cm line pressure;

5. 4.    Specialbearing steel 6000 hours wear resistant roll surface;

6. 5.    Closedgear reducer low noise without leakage;

7. 6.    Laboratoryof pressure ball to provide incoming material pressure ball test.

Gongyi Fu Yu Machinery Co., Ltd. is specialized inthe production of pressure ball machine, welcome to consult the factory,telephone 86-18538292735, . E-mail:fybriquettemachine@yahoo.com.