Aluminum Brass Rubber Elements , Zine Plated Surface Treatment Hook-headed

Aluminum Brass Rubber Elements , Zine Plated Surface Treatment Hook-headed

Specification:

   1.Hook device mainly as a vertical shaft sinking suspension bucket with ascension.

   2.Hook device in two varieties, four specifications. Type I hook device points 5 t and 7 t, Ⅱ hook device points 9 t,11t.

   3.Hook device structure is simple, usage the function is single. All parts by forging, steel wire rope connection adopted two kinds of type, including 5 t and 7 t with eccentric rope ring, the board connection; 9 t, 11 t the taper sleeve connection, lead antimony alloy casting by form.

Hook device adjustment and installation:

             1. Hook device connected to the hoisting rope well qualified through inspection, must carry out a light load for a short period of time (30% ~ 60%) as the design load test run, commissioning time is recommended for eight hours or ascend 15 times. To check the cable connection parts and hook device each have other parts without exception.

             2. Appearance inspection must be conducted before use, all rotating parts are in good lubrication, flexible rotation, the nut is loose, reliable insurance card.

             3.Tightness of pin-type insurance card spring has been adjusted, move can make bolt clamping with the hand, not loose. Work to avoid collision, the deformation, can not use levers, hammer instead of manual move.

 
 
After Sales Service For Marine Rubber Fender:
 
In marine environments, it is important to carry out scheduled Inspections and Maintenance on fender systems and related equipment to protect your investment and ensure safe, reliable and efficient operation.
 
Neptune Marine Equipment Co.,Ltd can assist to inspect/Maintain for your fender systems and repair procedures subsequently depending on:
 
1. Local climate
2. System type and frequency of usage
3. Type and range of vessels using the berth
4. Local resources and equipment
5. Initial system design
 
Inspections/Maintenance of above items are focused on providing the maximum life cycle for the fender system installed. Inspection intervals should be adjusted to suit local conditions and feedback from maintenance personnel.

 
Payment :  By T/T(30% prepaid as depsit, the balance 70% against copy of B/L )
 
Package: Pallet with film packing  or according to customer\'s requirement
 
Delivery time : Within 20 to 30 days, According t